Dodge Ram Truck 1500-2500-3500. Manual — part 166
RIGHT FRONT SENSOR SHORTED — 91 (CONTINUED)
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
Ignition on.
•
Set Condition:
The CAB detect high voltage on the wheel speed sensor circuit.
Possible Causes
INTERMITTENT RIGHT FRONT WHEEL SPEED SENSOR DTC
RIGHT FRONT WHEEL SPEED SENSOR (+) CIRCUIT SHORTED TO VOLTAGE
RIGHT FRONT WHEEL SPEED SENSOR (-) CIRCUIT SHORTED TO VOLTAGE
RIGHT FRONT WHEEL SPEED SENSOR (+) CIRCUIT SHORTED TO THE RIGHT FRONT WHEEL SPEED
SENSOR (-) CIRCUIT
TONE WHEEL
EXCESSIVE RIGHT FRONT WHEEL SPEED SENSOR AIR GAP
WHEEL BEARING
RIGHT FRONT WHEEL SPEED SENSOR
CONTROLLER ANTI-LOCK BRAKE
Diagnostic Test
1.
DTC IS ACTIVE
Turn the ignition on.
With the scan tool, clear DTCs.
Turn the ignition off.
Turn the ignition on.
With the scan tool, read DTCs.
Does the DRBIII
T
display the DTC?
Yes
>> Go To 2
No
>> Go To 11
2.
WHEEL SPEED SENSOR INSPECTION
Turn the ignition off.
Inspect the Wheel Speed Sensor for proper mounting.
Inspect the Wheel Speed Sensor harness and connector.
Inspect the Wheel Speed Sensor for excessive debris on the sensor.
Were any problems found?
Yes
>> Repair as necessary in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
No
>> Go To 3
5 - 92
BRAKES - ABS - ELECTRICAL DIAGNOSTICS
DR/DH
RIGHT FRONT SENSOR SHORTED — 91 (CONTINUED)
3.
TONE WHEEL DAMAGED/MISSING
Inspect the Tone Wheel in accordance with the Service Information.
NOTE: The Tone Wheel Teeth should be perfectly square, not bent or nicked.
Were any problems found?
Yes
>> Replace the Tone Wheel in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
No
>> Go To 4
4.
EXCESSIVE WHEEL SPEED SENSOR AIR GAP
Measure the Wheel Speed Sensor Air Gap in accordance with the Service Information.
Were any problems found?
Yes
>> Repair as necessary in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
No
>> Go To 5
5.
WHEEL BEARING LOOSE/BINDING
Inspect the wheel bearings for excessive run out or improper clearance in accordance with the Service Information.
Were any problems found?
Yes
>> Repair as necessary in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
No
>> Go To 6
6.
RIGHT FRONT WHEEL SPEED SENSOR (+) CIRCUIT
SHORTED TO VOLTAGE
Turn the ignition on.
Measure the voltage of the Right Front Wheel Speed Sensor (+) cir-
cuit.
Is there any voltage present?
Yes
>> Repair Right Front Wheel Speed Sensor (+) circuit for a
short to voltage.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 -
BRAKES/ELECTRICAL - DIAGNOSIS AND TESTING)
No
>> Go To 7
DR/DH
BRAKES - ABS - ELECTRICAL DIAGNOSTICS
5 - 93
RIGHT FRONT SENSOR SHORTED — 91 (CONTINUED)
7.
RIGHT FRONT WHEEL SPEED SENSOR (-) CIRCUIT SHORTED TO VOLTAGE
Measure the voltage of the Right Front Wheel Speed Sensor (-) circuit.
Is there any voltage present?
Yes
>> Repair the Right Front Wheel Speed Sensor (-) circuit for
a short to voltage.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 -
BRAKES/ELECTRICAL - DIAGNOSIS AND TESTING)
No
>> Go To 8
8.
RIGHT FRONT WHEEL SPEED SENSOR (+) CIRCUIT SHORTED TO THE RIGHT FRONT WHEEL SPEED
SENSOR (-) CIRCUIT
Turn the ignition off.
Measure the resistance between the Right Front Wheel Speed Sensor
(+) circuit and the Right Front Wheel Speed Sensor (-) circuit at the
Controller Anti-lock Brake harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Repair Right Front Wheel Speed Sensor (+) circuit for a
short to the Right Front Wheel Speed Sensor (-) circuit.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 -
BRAKES/ELECTRICAL - DIAGNOSIS AND TESTING)
No
>> Go To 9
5 - 94
BRAKES - ABS - ELECTRICAL DIAGNOSTICS
DR/DH
RIGHT FRONT SENSOR SHORTED — 91 (CONTINUED)
9.
RIGHT FRONT WHEEL SPEED SENSOR
Turn the ignition off.
Connect the Right Front Wheel Speed Sensor harness connector.
Measure the resistance between the Right Front Wheel Speed Sensor (+) circuit and Right Front Wheel Speed
Sensor (-) circuit at the Controller Anti-lock Brake harness connector.
NOTE: The resistance should be approximately 1600–2300 ohms at 76 degrees F.
Is the resistance within the noted range?
Yes
>> Go to 10
No
>> Replace the Right Front Wheel Speed Sensor in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
10.
CONTROLLER ANTI-LOCK BRAKE
Turn the ignition off.
Inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
Inspect the related wire harness connectors. Look for broken, bent, pushed out, or corroded terminals.
Refer to any Technical Service Bulletins that may apply.
Were any problems found?
Yes
>> Repair as necessary in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
No
>> Replace the Controller Anti-lock Brake in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
11.
WIRING HARNESS INSPECTION
Turn the ignition off.
NOTE: Towing the vehicle with ignition ON may set this DTC.
Inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
Inspect the related wire harness connectors. Look for broken, bent, pushed out, or corroded terminals.
Refer to any Technical Service Bulletins that may apply.
Were any problems found?
Yes
>> Repair as necessary in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND
TESTING)
No
>> Test Complete.
DR/DH
BRAKES - ABS - ELECTRICAL DIAGNOSTICS
5 - 95
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст