Dodge Ram Truck 1500-2500-3500. Manual — part 1532
4. Remove isolator plate (1) from transmission (2) .
5. Remove primary shift rail detent plug (1).
6. Remove primary shift rail detent spring (1).
21 - 60
MANUAL TRANSMISSION - NV5600 - SERVICE INFORMATION
DR/DH
7. Remove primary shift rail detent plunger (1).
8. Remove clutch housing bolts (1) from inside the
housing.
9. Remove shift rail blocker bolt (1) from transmission
case.
DR/DH
MANUAL TRANSMISSION - NV5600 - SERVICE INFORMATION
21 - 61
EXTENSION/ADAPTER HOUSING
1. Remove
extension/adapter
housing
bolts
from
transmission case.
2. Remove extension/adapter housing (2) from the
transmission gear case with Puller 8244 (1).
NOTE: Keep housing straight during removal due
to reverse idler shaft may bind on one side of the
housing.
3. Remove crossover detent plug (1), spring and
plunger from the extension/adapter housing (2).
4. Remove bolt (2) and washer holding the crossover
cam (1) to the extension/adapter housing (3).
5. Remove crossover cam from extension/adapter
housing.
6. Remove back-up lamp switch from extension/
adapter housing.
21 - 62
MANUAL TRANSMISSION - NV5600 - SERVICE INFORMATION
DR/DH
7. Remove countershaft rear bearing race from exten-
sion/adapter housing with Remover L-4518 (1).
NOTE: Tag all countershaft pre-load shims (1) from
between the bearing race (2) and the housing.
8. Remove crossover cam bushing from the exten-
sion/adapter housing with Remover 8240.
9. On 4X2 vehicles, remove extension housing seal
with a pry tool or a slide hammer and screw.
10. On 4X4 vehicles, remove adapter housing seal
with a pry tool or a slide hammer and screw.
TRANSMISSION GEAR CASE
1. Remove remaining bolts from transmission case to
the clutch housing.
2. Remove shift socket roll pin with a 6 mm (7/32 in.)
punch and hammer.
3. Turn shift socket so it won’t catch the case when
lifting it up.
4. Install Fixture 8232 (1) to the transmission case
(2).
5. Attach an engine crane or equivalent to Fixture
8232 and remove the transmission gear case from
the clutch housing.
6. Remove rear output shaft and countershaft bearing
races from the transmission gear case with a brass
drift and hammer.
DR/DH
MANUAL TRANSMISSION - NV5600 - SERVICE INFORMATION
21 - 63
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст