Dodge Ram Truck 1500-2500-3500. Manual — part 1392
NOTE: Clean and inspect oil pan gasket. The pan gasket can be used again if in good condition.
INSTALLATION
1. Clean gasket surfaces. Inspect oil pan gasket. Replace as necessary.
2. Apply an 1/8 in. bead of Mopar Engine RTV at the two joints between the cylinder block to timing chain case
cover and the two joints between the rear main seal retainer and engine block.
3. Position oil pan and gasket to engine block, seat the oil level indicator tube in the oil pan and hand start all
fasteners.
4. Tighten the transmission to oil pan bolts in finger
tight.
5. Torque 5/16-18 oil pan bolts to 23 N·m (200 in.
lbs.). Torque 1/4-20 oil pan bolts to 11 N·m (95 in
lbs.).
6. Torque transmission to oil pan bolts to 23 N·m (200
in. lbs.).
9 - 2490
ENGINE - 8.3L - SERVICE INFORMATION
DR/DH
7. Lower the engine.
8. Install and tighten engine mount through bolts to
102 N·m (75 ft. lbs.).
9. Install flywheel inspection cover.
10. Install frame front cross member (Refer to 13 -
FRAME & BUMPERS/FRAME/FRONT CROSS-
MEMBER - INSTALLATION).
11. Lower vehicle.
12. Install the oil level indicator tube fastener.
13. Fill the crankcase with the correct oil to proper
level.
14. Start the engine and inspect for leaks.
DR/DH
ENGINE - 8.3L - SERVICE INFORMATION
9 - 2491
PUMP-OIL
REMOVAL
NOTE: The oil pump is serviced with the timing
chain cover.
1. Remove timing chain cover (1) (Refer to 9 -
ENGINE/VALVE TIMING/TIMING CHAIN COVER -
REMOVAL).
2. Disassemble oil pump (3) (Refer to 9 - ENGINE/
LUBRICATION/OIL PUMP - DISASSEMBLY).
3. Inspect oil pump parts (Refer to 9 - ENGINE/LU-
BRICATION/OIL PUMP - INSPECTION).
DISASSEMBLY
1. Remove oil pump cover screws (1) and lift off
cover.
2. Remove pump rotors.
9 - 2492
ENGINE - 8.3L - SERVICE INFORMATION
DR/DH
3. Remove oil pressure relief valve (1) and spring (2).
4. Wash all parts in a suitable solvent and inspect
carefully for damage or wear.
CLEANING
Clean all parts thoroughly. Mating surface of the chain case cover should be smooth. Replace pump cover if
scratched or grooved.
INSPECTION
1. Lay a straightedge (1) across the pump cover sur-
face. If a 0.076 mm (0.003 in.) feeler gauge (2) can
be inserted between cover and straight edge, cover
should be replaced.
DR/DH
ENGINE - 8.3L - SERVICE INFORMATION
9 - 2493
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст