Dodge Ram Truck 1500-2500-3500. Manual — part 249
4.7L ENGINE
1. Position the transmission cooler tubes to the front
of the radiator by sliding brackets into slots on radi-
ator inlet tank.
2. Snap the transmission cooler tubes into the clips
on the side of the radiator tank.
3. Install
the
transmission
cooler
attaching
bolt.
Tighten the bolt to 16 N·m (140 in. lbs.).
4. Inspect the quick connect fittings for debris and
install the quick connect fitting on the cooler tube
until an audible “click” is heard. Pull apart the con-
nection to verify proper installation and install the
secondary latches (Refer to 7 - COOLING/TRANS-
MISSION - STANDARD PROCEDURE).
5. Start the engine and check all fittings for leaks.
6. Check the fluid level in the automatic transmission.
Refer
to
the
appropriate
transmission
section
(Refer to 21 - TRANSMISSION/TRANSAXLE/AU-
TOMATIC - 45RFE/545RFE/FLUID - STANDARD
PROCEDURE) or (Refer to 21 - TRANSMISSION/
TRANSAXLE/AUTOMATIC - 46RE/FLUID - STAN-
DARD PROCEDURE).
5.7L ENGINE
1. Position the transmission cooler tubes to the front
of the radiator by sliding brackets into slots on radi-
ator inlet tank.
2. Snap the transmission cooler tubes into the clips
on the side of the radiator tank.
3. Install
the
transmission
cooler
attaching
bolt.
Tighten the bolt to 16 N·m (140 in. lbs.).
4. Inspect the quick connect fittings for debris and
install the quick connect fitting on the cooler tube
until an audible “click” is heard. Pull apart the con-
nection to verify proper installation and install the
secondary latches (Refer to 7 - COOLING/TRANS-
MISSION - STANDARD PROCEDURE).
5. Start the engine and check all fittings for leaks.
6. Check the fluid level in the automatic transmission.
Refer
to
the
appropriate
transmission
section
(Refer to 21 - TRANSMISSION/TRANSAXLE/AU-
TOMATIC - 45RFE/545RFE/FLUID - STANDARD
PROCEDURE) or (Refer to 21 - TRANSMISSION/
TRANSAXLE/AUTOMATIC - 46RE/FLUID - STAN-
DARD PROCEDURE).
7 - 102
TRANSMISSION
DR/DH
AIR TO OIL COOLER - 5.9L DIESEL
1. Carefully position the oil cooler assembly to the
vehicle.
2. Install two nuts and one bolt. Tighten to 11 N·m (95
in. lbs.) torque.
3. Connect the quick-connect fittings to the transmis-
sion cooler lines.
4. Install Charge Air Cooler (Refer to 11 - EXHAUST
SYSTEM/TURBOCHARGER
SYSTEM/CHARGE
AIR COOLER AND PLUMBING - INSTALLATION).
5. Start the engine and check all fittings for leaks.
6. Check the fluid level in the automatic transmission
(Refer to 21 - TRANSMISSION/TRANSAXLE/AU-
TOMATIC
-
47RE/FLUID
-
STANDARD
PROCEDURE).
INSTALLATION - WATER-TO-OIL COOLER
1. Position oil cooler on cylinder block.
2. Install lower mounting bolt to cooler at the cylinder
block. Torque bolt to 77 N·m (57 ft. lbs.)
3. Install upper mounting bolt at the cylinder block.
Torque bolt to 24 N·m (18 ft. lbs.)
4. Install cooler bracket to transmission adapter bolt.
Tighten to 24 N·m (18 ft. lbs.).
NOTE: Use a back-up wrench on the transmission
cooler fittings to prevent damage to the cooler.
5. Connect transmission oil lines to cooler.
6. Connect coolant hoses to cooler.
7. Install starter motor (Refer to 8 - ELECTRICAL/
STARTING/STARTER MOTOR - INSTALLATION).
8. Connect battery negative cables.
9. Fill cooling system (Refer to 7 - COOLING - STAN-
DARD PROCEDURE).
10. Check transmission oil level and fill as necessary
(Refer to 21 - TRANSMISSION/TRANSAXLE/AU-
TOMATIC
-
47RE/FLUID
-
STANDARD
PROCEDURE).
DR/DH
TRANSMISSION
7 - 103
8.3L ENGINE
1. Carefully position the oil cooler assembly to the
vehicle.
2. Install two nuts and one bolt. Tighten to 11 N·m (95
in. lbs.) torque.
3. Connect the quick-connect fittings to the transmis-
sion cooler lines.
4. Start the engine and check all fittings for leaks.
5. Check the fluid level in the automatic transmission
(Refer to 21 - TRANSMISSION/TRANSAXLE/AU-
TOMATIC
-
47RE/FLUID
-
STANDARD
PROCEDURE).
7 - 104
TRANSMISSION
DR/DH
AUDIO/VIDEO
TABLE OF CONTENTS
page
page
AUDIO - SRT10 - AMP - ELECTRICAL
DIAGNOSTICS . . . . . . . . . . . . . . . . . . . . . . . . . . 89
AUDIO - ELECTRICAL DIAGNOSTICS
TABLE OF CONTENTS
page
page
AUDIO - ELECTRICAL DIAGNOSTICS
POWER AMP SHUTDOWN - BASE RADIO
REMOTE RADIO SWITCH CIRCUIT HIGH
REMOTE RADIO SWITCH CIRCUIT STUCK
. . . . . . . . . . . . . . . . . . . . . . . . . 17
ACROSS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
RIGHT FRONT DOOR CHANNEL SHORT
ACROSS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
LEFT REAR CHANNEL SHORT ACROSS
RIGHT REAR CHANNEL SHORT ACROSS
RIGHT FRONT I/P AND LEFT FRONT DOOR
CHANNELS SHORT ACROSS . . . . . . . . . . . . 23
RIGHT FRONT I/P AND RIGHT FRONT
DOOR CHANNELS SHORT ACROSS . . . . . . . 25
CHANNELS SHORT ACROSS . . . . . . . . . . . . 27
RIGHT FRONT I/P AND RIGHT REAR
CHANNELS SHORT ACROSS . . . . . . . . . . . . 29
RIGHT I/P SPEAKER AND BOTH REAR
CHANNELS SHORT ACROSS . . . . . . . . . . . . 31
RIGHT FRONT DOOR AND LEFT REAR
CHANNELS SHORT ACROSS . . . . . . . . . . . . 33
RIGHT FRONT DOOR AND RIGHT REAR
CHANNELS SHORT ACROSS . . . . . . . . . . . . 35
REAR SPEAKERS SHORT TOGETHER OR
TO GROUND . . . . . . . . . . . . . . . . . . . . . . . . . 37
. . . . . . . . . . . . . . . . . 48
CONNECTED . . . . . . . . . . . . . . . . . . . . . . . . . 49
AUDIO - ELECTRICAL DIAGNOSTICS
DIAGNOSIS AND TESTING
DR/DH
AUDIO/VIDEO
8A - 1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст