Dodge Ram Truck 1500-2500-3500. Manual — part 2092
5. Remove nuts (4) and remove NVLD filter support
bracket (2). Remove upper canister.
6. Remove nuts (5) and remove lower canister (6).
Slip lower canister pins (7) from rubber grommets.
25 - 40
EVAPORATIVE EMISSIONS
DR/DH
INSTALLATION
DR/DH
EVAPORATIVE EMISSIONS
25 - 41
Two EVAP canisters are used. Depending on vehicle model and fuel tank size, the canisters may be mounted either
vertically or horizontally. These maintenance free, EVAP canisters (5) are located near the front of the fuel tank.
25 - 42
EVAPORATIVE EMISSIONS
DR/DH
Type 1 Canisters
Use the following procedure for vertically mounted canisters.
1. Place each canister (5) and (6) into upper support bracket and install nuts. Refer to Torque Specifications.
2. Install lower support bracket (4). Refer to Torque Specifications.
3. Carefully install vapor/vacuum lines. The vapor/vacuum lines and hoses must be firmly connected. Also
check the vapor/vacuum lines at the NVLD Pump, LDP, LDP filter and EVAP canister purge solenoid for
damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
4. If necessary, install skid plate(s).
Type 2 Canisters
Use the following procedure for horizontally mounted canisters.
1 - CANISTER MOUNTING NUTS
2 - CONNECTING HOSE
3 - UPPER SUPPORT BRACKET
4 - LOWER SUPPORT BRACKET
5 - OUTER CANISTER
6 - INNER CANISTER
DR/DH
EVAPORATIVE EMISSIONS
25 - 43
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст