Dodge Ram Truck 1500-2500-3500. Manual — part 135
5. Align hole in pinion mate shaft (1) with hole in dif-
ferential case and install lock screw (3) with Loc-
tite
T
242 or equivalent. Tighten lock screw to 27
N·m (20 ft. lbs.).
6. Apply a bead of orange Mopar Axle RTV sealant
(2) or equivalent to the housing cover (1).
CAUTION: If housing cover is not installed within
3 to 5 minutes, the cover must be cleaned and
new RTV applied. Failure to follow these instruc-
tion will result in a leak.
7. Install cover and tighten bolts in a criss-cross pat-
tern to 48 N·m (35 ft. lbs.).
8. Fill differential lubricant to bottom of the fill plug
hole.
9. Install fill hole plug and tighten to 27 N·m (20 ft.
lbs.).
10. Install brake rotor and caliper adapter with caliper.
3 - 372
REAR AXLE - 248RBI
DR/DH
SEAL-AXLE SHAFT
REMOVAL
1. Remove axle shaft.
2. Remove axle shaft seal (1) from the end of the
axle tube (2) with a pry bar.
INSTALLATION
1. Remove any old sealer/burrs from axle tube.
2. Coat new seal lip with axle lubricant and install
seal with Installer 9343 (1) and Handle C-4171(2).
3. Install axle shaft.
DR/DH
REAR AXLE - 248RBI
3 - 373
BEARING-AXLE
REMOVAL
1. Remove axle shaft.
2. Remove axle seal with pry bar.
3. Position bearing (2) Receiver 9345 (1) on axle
tube.
4. Insert bearing Remover 6310 with Foot 6310-9 (3)
through receiver (2) and bearing (1).
3 - 374
REAR AXLE - 248RBI
DR/DH
5. Tighten Remove 6310 nut (1) to pull bearing (3)
into the receiver (3).
INSTALLATION
1. Remove any old sealer/burrs from axle tube.
2. Install axle shaft bearing with Installer 9344 (1) and
Handle C-4171 (2). Drive bearing in until tool con-
tacts the axle tube.
NOTE: Bearing is installed with the bearing part
number against the installer.
3. Coat new axle seal lip with axle lubricant and
install with Installer 9343 and Handle C-4171.
4. Install axle shaft.
DR/DH
REAR AXLE - 248RBI
3 - 375
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст