Dodge Ram Truck 1500-2500-3500. Manual — part 1899
ASSEMBLY
BEARINGS AND SEALS
1. Remove the input shaft bearing snap-ring from the
front case half with suitable snap-ring pliers.
2. Remove the input shaft bearing from the front case
half with Installer 6953 (3) and Handle C-4171 (2).
3. Install the input shaft bearing into the front case
half with Installer 8151 (3) inverted on Handle
C-4171 (2).
4. Install the input shaft bearing snap-ring into the
front case half with suitable snap-ring pliers.
21 - 1528
TRANSFER CASE - NV273 - SERVICE INFORMATION
DR/DH
5. Remove the front output shaft front bearing snap-
ring from the front case half.
6. Using Installer 6953 (3) and Handle C-4171 (2),
remove the front output shaft front bearing.
7. Start front output shaft front bearing in case. Then
seat bearing with Installer 8891 (2).
8. Install front output shaft bearing retaining ring.
DR/DH
TRANSFER CASE - NV273 - SERVICE INFORMATION
21 - 1529
9. Remove input gear pilot bearing by inserting a suit-
ably sized drift (1) into the splined end of the input
gear (2) and driving the bearing out with the drift
and a hammer.
10. Install new pilot bearing with Installer 9035.
11. Remove the front output shaft rear bearing with
the screw and jaws from Remover L-4454 (2) and
Cup 8148 (3).
21 - 1530
TRANSFER CASE - NV273 - SERVICE INFORMATION
DR/DH
12. Install new bearing with Tool Handle C-4171 (2)
and Installer 8128 (3).
13. The bearing bore is chamfered at the top. Install
the bearing so it is flush (1) with the lower edge of
this chamfer (2).
14. Remove seal from oil pump with suitable pry tool.
15. Install new seal in oil pump with Installer 7888 (2).
DR/DH
TRANSFER CASE - NV273 - SERVICE INFORMATION
21 - 1531
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст