Dodge Ram Truck 1500-2500-3500. Manual — part 1970
INSTALLATION
FRONT HOSES
1. Position the lower portion through the grommet in
the body (3).
2. Connect the new drain tube to the sunroof housing
(1) and test drainage.
3. Position the tube support clips (2) and seat fully.
4. Install headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION).
REAR HOUSING HOSE
1. Install the rear tube and seat the push pin fasten-
ers (2) fully. * Front tube shown, rear similar.
2. Position the lower portion through the grommet in
the body (3).
3. Connect the new drain tube to the sunroof housing
(1) and test drainage.
4. Install headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION).
MOTOR
DESCRIPTION
For service information refer to (Refer to 8 - ELECTRICAL/POWER TOP/MOTOR - DIAGNOSIS AND TESTING).
23 - 234
SUNROOF - SERVICE INFORMATION
DR/DH
SUNSHADE
REMOVAL
1. Remove the drain channel. (Refer to 23 - BODY/
SUNROOF/CHANNEL-DRAIN - REMOVAL)
2. Push up the front center of the sunshade (1) to pop
out the front two feet.
3. Rotate the sunshade (2) so that the other feet (1)
are removed from the guide track.
DR/DH
SUNROOF - SERVICE INFORMATION
23 - 235
INSTALLATION
1. Verify the sunshade track is free of obstructions
like the trim lace/ring.
2. Start with sunshade (2) at an angle with one foot
(1) in the track.
3. Rotate the sunshade so the other rear foot is in the
track as well as the 2 other feet (3) on the same
side as the first foot.
4. To insert the remaining two feet (2) apply force to
the middle front of sunshade (3) and guide them
into the track.
5. Check that all the feet are in the right track and
verify sunshade operation.
6. Install the drain channel. (Refer to 23 - BODY/
SUNROOF/CHANNEL-DRAIN - INSTALLATION)
SWITCH-SUNROOF
DESCRIPTION
For service information refer to (Refer to 8 - ELECTRICAL/POWER TOP/SWITCH - DIAGNOSIS AND TESTING).
23 - 236
SUNROOF - SERVICE INFORMATION
DR/DH
TRIM RING
REMOVAL
1. Remove the headliner. (Refer to 23 - BODY/INTE-
RIOR/HEADLINER - REMOVAL)
2. Remove the 12 nuts (1) and roll the trim ring off the
headliner off the retaining flanges (2).
INSTALLATION
1. Position trim ring support flanges (2) over the
headliner and seat the trim ring fully.
2. Install the 12 nuts (1) onto the support studs.
DR/DH
SUNROOF - SERVICE INFORMATION
23 - 237
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст