Dodge Sprinter. Manual — part 410
TEST
ACTION
APPLICABILITY
3
Disconnect the Central Timer Module C1 connector.
Disconnect the Master Door Lock Switch connector.
Measure the resistance between ground and the Driver Door Ajar Indicator Driver
circuit.
Is the resistance below 20000.0 ohms?
All
Yes
→ Repair the Driver Door Ajar Indicator Driver wire for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Central Timer Module.
Perform BODY VERIFICATION TEST - VER 1.
197
POWER DOOR LOCKS/RKE
DRIVER DOOR AJAR INDICATOR DRIVER CIRCUIT SHORT TO
GROUND —
Continued
Symptom:
PASSENGER DOOR AJAR INDICATOR DRIVER CIRCUIT SHORT
TO GROUND
When Monitored and Set Condition:
PASSENGER DOOR AJAR INDICATOR DRIVER CIRCUIT SHORT TO GROUND
When Monitored:
Whenever the battery is above 10.0 volts and the module is connected.
Set Condition:
Whenever the CTM senses resistance on the Passenger Door Ajar
Indicator Driver circuit for over 30 seconds, this code will set.
POSSIBLE CAUSES
DTC PRESENT
MASTER DOOR LOCK SWITCH SHORTED
CENTRAL TIMER MODULE SHORTED
PASSENGER DOOR AJAR INDICATOR DRIVER WIRE SHORT TO GROUND
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, record and erase DTC’s.
Cycle the ignition switch from ON to OFF to ON.
With the DRBIII
t, read DTC’s.
Operate the Door Locks several times while observing the DRBIII
t.
Wait 10 seconds.
Does the DRBIII
t display PASSENGER DOOR AJAR INDICATOR CIRCUIT
SHORT TO GROUND?
All
Yes
→ Go To 2
No
→ The conditions that caused this code to set are not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition off.
Disconnect the Master Door Lock Switch connector.
Measure the resistance between ground and the Passenger Door Ajar Indicator
Driver circuit..
Is the resistance below 1000.0 ohms?
All
Yes
→ Go To 3
No
→ Replace the Master Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
198
POWER DOOR LOCKS/RKE
TEST
ACTION
APPLICABILITY
3
Disconnect the Central Timer Module C1 connector.
Disconnect the Master Door Lock Switch connector.
Measure the resistance between ground and the Passenger Door Ajar Indicator
Driver circuit.
Is the resistance below 20000.0 ohms?
All
Yes
→ Repair the Passenger Door Ajar Indicator Driver wire for a short
to ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Central Timer Module.
Perform BODY VERIFICATION TEST - VER 1.
199
POWER DOOR LOCKS/RKE
PASSENGER DOOR AJAR INDICATOR DRIVER CIRCUIT SHORT TO
GROUND —
Continued
Symptom:
REPLACE CONTROL MODULE
When Monitored and Set Condition:
REPLACE CONTROL MODULE
When Monitored:
Whenever the battery voltage is above 10.0 volts and the module is
connected.
Set Condition:
The SKREEM has detected an internal failure and must be replaced.
POSSIBLE CAUSES
CTM INTERNAL FAILURE
TEST
ACTION
APPLICABILITY
1
View repair.
All
Repair
Replace the Sentry Key RemotE Entry Module in accordance with
Service Instructions.
Perform BODY VERIFICATION TEST - VER 1.
200
POWER DOOR LOCKS/RKE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст