Dodge Sprinter. Manual — part 220
#8932 CRANKSHAFT LOCK
#8936 FRONT CRANKSHAFT SEAL INSTALLER
#8938A EXTRACTION CLAW
#8940 VIBRATION DAMPER REMOVER
9 - 18
ENGINE
VA
#8941 SLIDE HAMMER
#8942 OIL JET INSTALLER
#8944 REAR MAIN SEAL INSTALLER
#9307 VALVE SERVICE TOOLS
VA
ENGINE
9 - 19
#8951 ASSEMBLY LINKS
#9285 FUEL LINE WRENCH
# 9286 GLOW PLUG PLIERS
#9295 COMPRESSION HOSE ADAPTOR
#9525 TIMING CHAIN GUIDE
# 9539 FUEL LINE PLIERS
9 - 20
ENGINE
VA
AIR CLEANER ELEMENT
REMOVAL
(1) Remove heat shield.
(2) Disconnect air flow sensor from housing (Fig.
10).
(3) Unclip the air cleaner housing lid (Fig. 10).
(4) Remove air cleaner element (Fig. 10).
INSTALLATION
(1) Position and seat the air cleaner element into
the lower housing (Fig. 10).
(2) Install the housing cover and snap retainers
into place (Fig. 10).
(3) Install air flow sensor into housing cover and
connect. (Fig. 10).
(4) Connect the air cleaner restriction sensor (Fig.
10)..
(5) Install heat shield.
AIR CLEANER HOUSING
REMOVAL
(1) Disconnect the negative battery cable.
(2) Remove the heat shield.
(3) Remove the air flow sensor (Refer to 14 - FUEL
SYSTEM/FUEL
INJECTION/MANIFOLD
AIR
FLOW (MAF) SENSOR - REMOVAL).
(4) Disconnect the air intake pressure sensor,
unclip the top of the air cleaner housing and remove
(Fig. 11).
(5) Take out air cleaner element (Fig. 11).
(6) Detach bottom part of the air cleaner housing
at the body (Fig. 11).
(7) Take air intake hose out of inner fender and
out of the rubber bushing in the wheel housing liner,
then detach it at the bottom part of the air cleaner
housing (Fig. 11).
#9543 ADAPTOR
#9544 VIBRATION DAMPER PULLER
Fig. 10 AIR CLEANER ELEMENT
1 - AIR CLEANER HOUSING COVER
2 - AIR FLOW SENSOR
3 - AIR CLEANER ELEMENT
4 - AIR CLEANER HOUSING
VA
ENGINE
9 - 21
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст