Dodge Caliber. Manual — part 1195
MECHANISM-GEAR SHIFT
REMOVAL
1. Remove gear shift knob (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/MANUAL/GEAR SHIFT KNOB
- REMOVAL).
2. Remove gear shift boot (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/MANUAL/GEAR SHIFT BOOT
- REMOVAL).
3. Remove the center console assembly (Refer to 23
-
BODY/INTERIOR/CENTER
CONSOLE
-
REMOVAL). Remove rear power window switch (if
equipped) and disconnect harness from console.
NOTE: Cable is pushed into a rubber grommet
4. Remove crossover cable (2) from shift lever (1).
5. Remove selector cable retaining clip (3) and dis-
connect cable (2) from the shift lever (1).
PM
T355 MANUAL TRANSAXLE
21 - 79
6. Remove The shifter assy. to floor pan bolts and
remove shifter from vehicle.
INSTALLATION
1. Install shifter assy. (1) to floor pan. Install and
torque bolts to 7N·m (61 in. lbs.).
21 - 80
T355 MANUAL TRANSAXLE
PM
2. Install selector cable (2) to shifter lever (1) and
secure cable to shifter bracket with clip (3).
3. Install crossover cable to shifter lever and secure
cable to shifter bracket.
4. Install center console assembly. Install rear power
window switch (if equipped) and fasten harness to
console (Refer to 23 - BODY/INTERIOR/CENTER
CONSOLE - INSTALLATION).
5. Install gearshift boot (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/MANUAL/GEAR SHIFT BOOT
- INSTALLATION).
6. Install gearshift knob (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/MANUAL/GEAR SHIFT KNOB
- INSTALLATION).
7. Verify that shift pattern is aligned properly.
PM
T355 MANUAL TRANSAXLE
21 - 81
BEARING AND SLEEVE-INPUT
REMOVAL
The input bearing (3) is a one-piece bearing and
sleeve unit. The sleeve is the slide point for the clutch-
release bearing and lever.
1. Install Driver 6342 (1) over input bearing on the
gear case side of the transaxle clutch housing (2).
2. Press the input bearing (3) out of the housing.
INSTALLATION
1. Apply coating of Loctite
T
sealant on bearing outer
diameter. Position sleeve and bearing assembly at
input bearing bore.
2. Install Seal Remover C-4680-1 (1), over input
bearing.
21 - 82
T355 MANUAL TRANSAXLE
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст