Dodge Caliber. Manual — part 370
3. Pull straight back on the tail lamp unit (5) to
release it from the quarter panel (4).
4. Disconnect the three electrical connectors (1, 2,
and 3) to the tail lamp unit (5).
5. Remove the tail lamp unit (5) from the vehicle.
6. Remove the bulb sockets from the lamp unit by
rotating the sockets counterclockwise, and then pull
straight out of the unit.
EXPORT
The BUX tail lamp unit comes out the same way as
the domestic, with the difference being the location of
the electrical connectors (1, 2, and 3). They incorpo-
rate a rear fog lamp in the tail lamp assembly.
INSTALLATION
BULBS
There are a total of four possible bulbs in the tail lamp
unit:
•
Back-Up Lamp (4)
•
Park/Brake Lamp (1)
•
Rear Fog Lamp (5) - Export Only
•
Turn Signal (3)
PM
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 113
1. Push bulb into the bulb socket.
2. Install bulb socket into tail lamp assembly. Rotate
the socket clockwise until fully seated.
3. Install the tail lamp unit (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING
-
EXTERIOR/TAIL
LAMP
-
INSTALLATION).
UNIT
DOMESTIC
If replacing the tail lamp unit (5) with a new one,
transfer the bulb sockets to the new unit (5).
1. Position the tail lamp unit (5) near the quarter
panel (4),
2. Connect the three electrical connectors (1, 2, and
3).
3. Align the ball and socket retainers in the quarter
panel (4) and firmly push forward until the tail lamp
(5) snaps into place.
4. Install the push pin retainers (2) to the tail lamp
unit (1).
5. Connect the battery negative cable.
EXPORT
If replacing the tail lamp unit (5) with a new one,
transfer the bulb sockets to the new unit (5). Remem-
ber that there is a rear fog lamp bulb in the BUX tail
lamp unit.
1. Install the tail lamp unit (5). Follow the same pro-
cedure as the domestic Step 1.
8L - 114
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
PM
LAMPS/LIGHTING - INTERIOR
TABLE OF CONTENTS
page
page
LAMPS/LIGHTING - INTERIOR
B161A-COURTESY/DOME LAMP CONTROL
CIRCUIT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 117
B161E-READING LAMP CONTROL CIRCUIT . 120
PM
LAMPS/LIGHTING - INTERIOR
8L - 115
LAMPS/LIGHTING - INTERIOR
DIAGNOSIS AND TESTING
8L - 116
LAMPS/LIGHTING - INTERIOR
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст