Dodge Caliber. Manual — part 1124
INSTALLATION
1. Lift fascia (2) and fasten both sides of fascia notch
(3) onto push pin (6).
2. Install fasteners (1) located inside wheel well up
through fascia.
3. Install fascia fasteners (7).
4. Install fascia fasteners (8) through fascia.
5. If equipped, connect wire harness (5) to fog lamp
(4).
6. Raise vehicle.
7. Install push pins into locations (1).
8. Install fasteners (2).
PM
FRAME & BUMPERS
13 - 7
REAR BUMPER FASCIA
REMOVAL
1. Remove push pins (5) from holes (1) located on
vehicle (2).
2. Remove rear splash shields.
3. Remove both left (7) and right screws (4).
4. Remove fascia from push pins (10).
INSTALLATION
1. Raise fascia (6) and hang fascia onto push pins
(10).
2. Install push pins (5) into push pin locations (1).
3. Install left (7) and right (4) screws into their respec-
tive locations.
4. Install splash shields.
13 - 8
FRAME & BUMPERS
PM
REAR BUMPER REINFORCEMENT
REMOVAL
1. Remove rear fascia. (Refer to 13 - FRAME &
BUMPERS/BUMPERS/REAR
BUMPER
-
REMOVAL)
2. Remove seven bumper reinforcement nuts (1).
3. Remove bumper reinforcement (2).
INSTALLATION
1. Place bumper reinforcement (2) up to frame loca-
tions.
2. Install seven nuts (1) and tighten to 23 N·m (204
in. lbs.)
3. Install fascia. (Refer to 13 - FRAME & BUMPERS/
BUMPERS/REAR BUMPER - INSTALLATION)
PM
FRAME & BUMPERS
13 - 9
FRONT FASCIA CLOSEOUT PANEL
REMOVAL
1. Remove fasteners and push pins.
INSTALLATION
1. Install fasteners and push pins.
13 - 10
FRAME & BUMPERS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст