Dodge Caliber. Manual — part 494
5. Remove the bolt (4) attaching the turning loop to
the belt height adjuster (2).
6. Remove upper B-pillar trim (3) (Refer to 23 -
BODY/INTERIOR/B-PILLAR TRIM - REMOVAL)
and lower B-pillar trim panels (Refer to 23 - BODY/
INTERIOR/B-PILLAR LOWER TRIM - REMOVAL).
7. Using a trim stick or equivalent, gently pry the seat-
belt webbing guide from the B-pillar (1).
8. Remove anchor bolt (6) from lower B-pillar (1)
.
9. Disconnect electrical connectors. One is for the
tensioner squib (2) and the other is for the seat belt
switch (3).
10. Remove front seat belt retractor (1) from vehicle.
PM
RESTRAINTS - SERVICE INFORMATION
8O - 373
INSTALLATION
WARNING: Due to the integral tensioners, the front
seat belt retractor assemblies must be replaced
following a collision where the airbags were
deployed.
1. Position the front seat belt retractor (1) into B-pillar
pocket.
2. Connect electrical connectors. One is for the ten-
sioner squib (2) and the other is for the seat belt
switch (3).
3. Install the anchor bolt (6) to the lower B-pillar (1).
Tighten bolt to 40 N·m (29.5 ft. lbs.).
4. Install the seatbelt webbing guide into the B-pillar
(1).
5. Install the lower B-pillar trim (Refer to 23 - BODY/
INTERIOR/B-PILLAR LOWER TRIM - INSTALLA-
TION) and upper B-pillar trim (3) (Refer to 23 -
BODY/INTERIOR/B-PILLAR
TRIM
-
INSTALLA-
TION).
6. Install the bolt (4) attaching the turning loop to the
belt height adjuster (2). Tighten bolt to 40 N·m
(29.5 ft. lbs.).
8O - 374
RESTRAINTS - SERVICE INFORMATION
PM
7. Install the plastic turning loop cover (2) onto the
height adjuster (1).
8. Install the lower webbing anchor bolt (2) to the seat
cushion frame (4). Tighten bolt to 51 N·m (37.5 ft.
lbs.).
9. Install the trim cover (1) to the retractor lower
anchor bolt (2).
WARNING: Do not connect the battery negative
cable (Refer to 8 - ELECTRICAL/RESTRAINTS -
DIAGNOSIS AND TESTING - AIRBAG SYSTEM).
Personal injury or death may result if the system
test is not performed first.
PM
RESTRAINTS - SERVICE INFORMATION
8O - 375
FRONT SEAT BELT BUCKLE
REMOVAL
NOTE: Graphic is of seatbelt retractor anchor bolt,
buckle is same mounting but on the outboard side
of the seat cushion frame.
1. Using a trim stick or equivalent, gently pry off the
trim cover (1) to the seatbelt buckle bolt (2).
2. Remove the buckle anchor bolt (2).
INSTALLATION
NOTE: Graphic is of seatbelt retractor anchor bolt,
buckle is same mounting but on the outboard side
of the seat cushion frame.
1. Install the seatbelt buckle and then the anchor bolt
(2). Tighten bolt to 51 N·m (37.5 ft. lbs.).
2. Install the trim cover (1) to the seatbelt buckle bolt
(2).
8O - 376
RESTRAINTS - SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст