Dodge Caliber. Manual — part 1102
![](/vehicles/wlang/mes/adolos/yoge.png)
9. Lightly tap Wedge 9701(2) into place.
10. Remove the front camshaft bearing cap.
11. Slowly remove the remaining camshaft bearing
bolts one turn at a time following the above
sequence.
12. Remove intake camshaft (1) by lifting the rear of
the camshaft upward.
PM
ENGINE 2.4L WORLD
9 - 1695
![](/vehicles/wlang/mes/adolos/tselove.png)
13. Rotate the camshaft while lifting out of the front
bearing cradle.
14. Lift the timing chain (2) off the sprocket (1).
15. Remove exhaust camshaft.
CLEANING
Clean camshafts with a suitable solvent.
INSPECTION
1. Inspect camshaft bearing journals for damage and
binding. If journals are binding, check the cylinder
head for damage. Also check cylinder head oil
holes for clogging.
2. Check the cam lobe and bearing surfaces for
abnormal wear and damage. Replace camshaft if
defective.
NOTE: If camshaft is replaced due to lobe wear or
damage, always replace the lash buckets.
9 - 1696
ENGINE 2.4L WORLD
PM
![](/vehicles/wlang/mes/adolos/qup.png)
INSTALLATION
1. Identify which front cam cap (1) is installed on the
engine you are working on.
2. The cam cap (1) is numbered (2) either one, two,
or three, this corresponds to the select fit bearing
to use.
3. Install the corresponding select fit bearing that will
also be numbered (1) one, two, or three.
4. Oil all of the camshaft journals with clean engine
oil.
5. Install exhaust camshaft and position on bearing
journals in the cylinder head.
6. Align exhaust cam timing mark so it is parallel to
the cylinder head as shown.
PM
ENGINE 2.4L WORLD
9 - 1697
![](/vehicles/wlang/mes/adolos/gel.png)
7. Install timing chain onto exhaust cam sprocket
making sure that the timing marks (1) on the
sprocket and chain are aligned.
8. Install intake camshaft by raising the rear of the
camshaft upward and roll the sprocket into the
chain.
9. Align the timing marks (1) on the intake cam
sprocket with the mark in the chain.
10. Position the intake camshaft into the bearing jour-
nals in the cylinder head.
11. Verify that the timing marks (1) are aligned on
both camshafts and that the timing marks (3) are
parallel with the cylinder head.
CAUTION: Install the front intake and exhaust camshaft bearing cap last. Ensure that the dowels are seated
and follow torque sequence or damage to engine could result.
9 - 1698
ENGINE 2.4L WORLD
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст