Dodge Caliber. Manual — part 1361
3. Remove the hog rings (2) connecting the seat
cover (3) to the seat cushion foam (1) and sepa-
rate from the seat cushion frame.
ASSEMBLY
1. Place the cushion cover (3) onto the cushion foam
(1) and install new hog rings (2).
2. Connect the J-straps (1) to the seat cushion frame.
3. Install the seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION - REAR - INSTALLATION)
PM
SEATS
23 - 181
INSTALLATION
1. Place the seat cushion into the vehicle and tuck the rear of the cushion (1) up under the seat belt buckles and
rear seat back.
2. Lower the front of the cushion (3) down and install the bolts (2).
3. Tighten the bolts to 56 N·m (41.5 ft. lbs.).
23 - 182
SEATS
PM
STATIONARY GLASS
TABLE OF CONTENTS
page
page
STATIONARY GLASS
WINDSHIELD SAFETY PRECAUTIONS . . . . . . 184
QUARTER GLASS
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 185
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 185
WINDSHIELD
PM
STATIONARY GLASS
23 - 183
STATIONARY GLASS
WARNING
WINDSHIELD SAFETY PRECAUTIONS
WARNING: Do not operate the vehicle within 24 hours of windshield installation. It takes at least 24 hours
for urethane adhesive to cure. If it is not cured, the windshield may not perform properly in an accident.
•
Urethane adhesives are applied as a system. Use glass cleaner, glass prep solvent, glass primer, PVC
(vinyl) primer and pinch weld (fence) primer provided by the adhesive manufacturer. If not, structural
integrity could be compromised.
•
DaimlerChrysler does not recommend glass adhesive by brand. Technicians should review product labels
and technical data sheets, and use only adhesives that their manufactures warrant will restore a vehicle
to the requirements of FMVSS 212. Technicians should also insure that primers and cleaners are com-
patible with the particular adhesive used.
•
Be sure to refer to the urethane manufacturer’s directions for curing time specifications, and do not use
adhesive after its expiration date.
•
Vapors that are emitted from the urethane adhesive or primer could cause personal injury. Use them in a
well-ventilated area.
•
Skin contact with urethane adhesive should be avoided. Personal injury may result.
•
Always wear eye and hand protection when working with glass.
CAUTION: Protect all painted and trimmed surfaces from coming in contact with urethane or primers.
Be careful not to damage painted surfaces when removing moldings or cutting urethane around windshield.
23 - 184
STATIONARY GLASS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст