Dodge Neon / Neon SRT-4. Manual — part 254
Crankshaft Damper/Sprocket Installer 6792
Valve Spring Compressor 8215-A
Adaptor 8436
Valve Spring Compressor MD-998772-A
Valve Spring Compressor Adapter 6779
Cylinder Bore Gage C-119
Connecting Rod Guides 8189
Crankshaft Sprocket Remover 6793
Crankshaft Sprocket Remover Insert C-4685-C2
9 - 110
ENGINE 2.4L DOHC TURBO
PL/SRT-4
ENGINE 2.4L DOHC TURBO (Continued)
Crankshaft Front Seal Remover 6771
Oil Pressure Gage C-3292
Adaptor 8406
Driver Handle C-4171
Rear Crankshaft Seal Guide and Installer 6926-1 and
6926-2
Balance Shaft Sprocket Installer 6052
Post Adapter 8130
Front Crankshaft Oil Seal Installer 6780
PL/SRT-4
ENGINE 2.4L DOHC TURBO
9 - 111
ENGINE 2.4L DOHC TURBO (Continued)
Combustion Leak Tester C-3685-A
Cooling System Tester 7700
Pressure Transducer CH7059
Cylinder Compression Pressure Adaptor 8116
DRB III
T
with PEP Module OT-CH6010A
9 - 112
ENGINE 2.4L DOHC TURBO
PL/SRT-4
ENGINE 2.4L DOHC TURBO (Continued)
AIR CLEANER ELEMENT
REMOVAL
(1) Remove the air cleaner housing cover screws
(Fig. 14).
(2) Partially raise air cleaner housing cover.
(3) Remove air cleaner element.
(4) If necessary, clean the inside of the air cleaner
housing.
INSTALLATION
(1) Install the air filter element on locator (Fig. 15)
and then make sure that the element is locked in at
the lip in the air cleaner housing (Fig. 16).
(2) Lower air cleaner housing cover until properly
seated.
(3) Install the air cleaner housing cover screws
(Fig. 14).
Fig. 14 Air Cleaner Housing Cover
1 - AIR CLEANER HOUSING COVER SCREWS (5)
Fig. 15 Element Locator
1 - ELEMENT LOCATOR
Fig. 16 Air Cleaner Housing Lip
1 - LIP
PL/SRT-4
ENGINE 2.4L DOHC TURBO
9 - 113
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст