Dodge Dakota (R1). Manual — part 19
TEST
ACTION
APPLICABILITY
4
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED.
View repair.
All
Repair
Replace the Airbag Control Module in accordance with Service
Instructions. WARNING: make sure the battery is disconnected
and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
Note: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
73
AIRBAG
PASSENGER SQUIB CIRCUIT OPEN - ACTIVE —
Continued
Symptom:
PASSENGER SQUIB CIRCUIT SHORT - ACTIVE
When Monitored and Set Condition:
PASSENGER SQUIB CIRCUIT SHORT - ACTIVE
When Monitored:
When the ignition is on, the ACM monitors the resistance of the
Passenger Squib circuits.
Set Condition:
The ACM has detected low resistance in the Passenger Squib circuits.
POSSIBLE CAUSES
PASSENGER AIRBAG MODULE SHORT
PASSENGER AIRBAG LINE 1 SHORT TO LINE 2
ACM, PASSENGER AIRBAG SHORT
TEST
ACTION
APPLICABILITY
1
NOTE: Ensure the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the Airbag System Load Tool 8443 Passenger cable and jumper harness to
the Passenger Airbag connector.
Turn the ignition on.
Reconnect the battery.
With the DRBIII
t, read active Airbag DTCs.
Does the DRB show PASSENGER SQUIB CIRCUIT SHORT?
All
Yes
→
No
→
Replace Passenger Airbag.
Perform AIRBAG VERIFICATION TEST - VER 1.
Note: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
74
AIRBAG
TEST
ACTION
APPLICABILITY
2
NOTE: Ensure the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag connector.
Disconnect the Airbag Control Module connector
NOTE: Check connectors - Clean and repair as necessary.
Connect the Airbag System Load Tool 8310 ACM adaptor to the Airbag Control
Module connector.
Measure the resistance between the Passenger Airbag Line 1 and Line 2 circuit at the
Load Tool ACM Adaptor.
Is the resistance below 10.0K ohms?
All
Yes
→
Repair the Passenger Airbag Line 1 circuit for a short to the
Passenger Airbag Line 2 circuit.
Perform AIRBAG VERIFICATION TEST - VER 1.
No
→
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
3
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED.
View repair.
All
Repair
Replace the Airbag Control Module in accordance with Service
Instructions. WARNING: make sure the battery is disconnected
and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
75
AIRBAG
PASSENGER SQUIB CIRCUIT SHORT - ACTIVE —
Continued
Symptom:
PASSENGER SQUIB SHORT TO BATTERY - ACTIVE
When Monitored and Set Condition:
PASSENGER SQUIB SHORT TO BATTERY - ACTIVE
When Monitored:
When the ignition is on, the ACM monitors the voltage of the Passenger
Squib circuits.
Set Condition:
The ACM has detected high voltage on the Passenger Squib circuits.
POSSIBLE CAUSES
PASSENGER AIRBAG SHORT TO BATTERY
PASSENGER AIRBAG CIRCUIT LINE 1 SHORT TO BATTERY
PASSENGER AIRBAG CIRCUIT LINE 2 SHORT TO BATTERY
ACM, PASSENGER AIRBAG SHORT TO VOLTAGE
TEST
ACTION
APPLICABILITY
1
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
CAUTION: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the Airbag System Load Tool 8310 brown cable and jumper harness to the
Passenger Airbag connector.
Turn ignition On and then reconnect the Battery.
With the DRBIII
t, read active DTCs.
Does the DRB show PASSENGER SQUIB CIRCUIT SHORT TO BATTERY?
All
Yes
→
No
→
Replace Passenger Airbag Module.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
76
AIRBAG
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст