Dodge Nitro. Manual — part 225
Fig. 15: Solenoid Valve & Seal
Courtesy of CHRYSLER LLC
1. Clean any debris off the mating surfaces of the HCU and ABM module.
2. If the seals on the components are not new, they must be replaced. Each of the solenoid valve stem seals
(1) must be replaced. See Fig. 15 do not reuse solenoid valve stem seals .
1 - SEAL
2 - SOLENOID VALVE STEM
CAUTION: When installing new O-rings or solenoid valve stem seals, do not use
any type of lubricant.
2007 Dodge Nitro R/T
2007 BRAKES ABS Service Information - Nitro
Fig. 16: O-Ring & O-Ring Mounting Groove
Courtesy of CHRYSLER LLC
3. The pump/motor connector O-ring (1) should also be replaced if not new. See Fig. 16
1 - O-RING
2 - O-RING MOUNTING GROOVE
2007 Dodge Nitro R/T
2007 BRAKES ABS Service Information - Nitro
Fig. 17: Identifying ABM, HCU & Solenoid Valve Stem
Courtesy of CHRYSLER LLC
4. Align components and install the ABM module on the HCU. See Fig. 17.
1 - ABM
2 - HCU
3 - SOLENOID VALVE STEM
2007 Dodge Nitro R/T
2007 BRAKES ABS Service Information - Nitro
Fig. 18: ABM & Mounting Screws
Courtesy of CHRYSLER LLC
5. Install the four screws attaching the ABM module to the HCU. See Fig. 18. Tighten the mounting screws
to 2 N.m (17 in. lbs.) torque.
6. If the mounting bracket needs to be installed, install the mounting pins in the HCU as necessary and
tighten to 14 N.m (125 in. lbs.) torque. Insert the mounting pins into the grommets mounted in the
bracket, then install the single mounting bolt. Tighten the mounting bolt to 14 N.m (125 in. lbs.) torque.
7. Install the HCU in the vehicle. See INSTALLATION.
INSTALLATION
HYDRAULIC CONTROL UNIT
1 - MOUNTING SCREWS
2 - ABM
2007 Dodge Nitro R/T
2007 BRAKES ABS Service Information - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст