Dodge Nitro. Manual — part 786
Diagnostic Test
1) PCM FROM ANOTHER VEHICLE INSTALLED
Has another PCM been installed?
Yes
Replace the PCM in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
No
Go to 2).
2) OTHER CAN-C MODULES SET VIN MISMATCH
Is VIN Mismatch DTC set in other CAN-C modules?
Yes
Replace the PCM in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
No
Replace the TIPM in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
B222C-VEHICLE CONFIGURATION NOT PROGRAMMED
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
When Monitored:
Continuously
Set Condition:
The TIPM is not configured for the vehicle.
Possible Causes
PCM FROM ANOTHER VEHICLE INSTALLED
NOTE:
This DTC is set when a PCM from another vehicle is installed into the
current vehicle.
2007 Dodge Nitro R/T
2007 ENGINE Ignition Control - Electrical Diagnostics - Nitro
Diagnostic Test
1) CHECK FOR ACTIVE DTC
Turn the ignition on.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
Go to 2).
No
Test complete.
2) ACTIVE TIPM DTC
Cycle the ignition from off to run remaining in run.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
Go to 3).
No
Test complete.
3) VIN MISMATCH DTC PRESENT
Turn the ignition on.
With the scan tool, read DTCs.
Is DTC: B2206-CURRENT VIN MISSING/MISMATCH also active?
Yes
Refer to repair procedure for B2206-CURRENT VIN MISSING/MISMATCH.
Possible Causes
TIPM
2007 Dodge Nitro R/T
2007 ENGINE Ignition Control - Electrical Diagnostics - Nitro
No
Replace the TIPM in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
U0100-LOST COMMUNICATION WITH ECM/PCM
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0101-LOST COMMUNICATION WITH TCM
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0114-LOST COMMUNICATION WITH FINAL DRIVE CONTROL MODULE
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0121-LOST COMMUNICATION WITH ANTI-LOCK BRAKE MODULE
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0151-LOST COMMUNICATION WITH OCCUPANT RESTRAINT CONTROLLER
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0154-LOST COMMUNICATION WITH OCCUPANT CLASSIFICATION MODULE
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0155-LOST COMMUNICATION WITH CLUSTER/CCN
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
2007 Dodge Nitro R/T
2007 ENGINE Ignition Control - Electrical Diagnostics - Nitro
U0164-LOST COMMUNICATION WITH HVAC CONTROL MODULE
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0168-LOST COMMUNICATION WITH VEHICLE SECURITY CONTROL MODULE (SKREEM/WCM)
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0184-LOST COMMUNICATION WITH RADIO
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
U0186-LOST COMMUNICATION WITH AUDIO AMPLIFIER
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
Refer to DIAGNOSIS AND TESTING for the diagnostic test procedure
2007 Dodge Nitro R/T
2007 ENGINE Ignition Control - Electrical Diagnostics - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст