Dodge Nitro. Manual — part 835
Fig. 77: 1St Gear & Bearing
Courtesy of CHRYSLER LLC
14. Install first gear (1) and bearing (2). Then center 1-2 synchronizer sleeve on synchronizer hub.
2007 Dodge Nitro R/T
2007 MANUAL TRANSMISSION NSG370 - Diagnosis & Overhaul - Nitro
Fig. 78: First Gear Thrust Washer & Reverse Gear Bearing Race
Courtesy of CHRYSLER LLC
WARNING:
Use welding gloves when handling heated components. Failure to
follow these instructions will result in personal injury.
CAUTION: A bearing heater is used to assemble first gear thrust washer (1) and
reverse gear bearing race (2). Use only a bearing heater/hot plate and
follow manufacture's instructions. Heat components to 100 - 177
Celsius (212° Min. - 350° Max Fahrenheit). Never use an open flame to
heat components. Never leave components on heater for and
extended amount of time. If component is discolored after heating,
2007 Dodge Nitro R/T
2007 MANUAL TRANSMISSION NSG370 - Diagnosis & Overhaul - Nitro
15. Heat first gear thrust washer (1) and reverse gear bearing race (2) with bearing heater to maximum of 177
Celsius (350°).
Fig. 79: First Gear Thrust Washer & Reverse Gear Bearing Race
Courtesy of CHRYSLER LLC
16. Using welding gloves or tongs, install first gear thrust washer (1) then reverse gear bearing race (2).
the component has been overheated and must not be used. Failure to
follow these instructions will result in component damage.
2007 Dodge Nitro R/T
2007 MANUAL TRANSMISSION NSG370 - Diagnosis & Overhaul - Nitro
Fig. 80: Identifying Reverse Gear & Bearing
Courtesy of CHRYSLER LLC
17. Install reverse gear (1) and bearing (2).
2007 Dodge Nitro R/T
2007 MANUAL TRANSMISSION NSG370 - Diagnosis & Overhaul - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст