Dodge Nitro. Manual — part 414

MOLDING - FRONT WHEEL OPENING FLARE

REMOVAL

MOLDING - FRONT WHEEL OPENING FLARE

Fig. 249: Removing/Installing Rivets Connecting Fender Flare To Wheel House Liner
Courtesy of CHRYSLER LLC

1. Remove four rivets connecting the fender flare to the wheel house liner.

Fig. 250: Removing/Installing Fender Flare Molding
Courtesy of CHRYSLER LLC

1 - Front Flare Clip
2 - Rear Flare Clip
3 - Front Flare Molding

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro

2. Using a trim stick C-4755 or equivalent, separate the front flare clips from the front of the molding (1),

and rear flare clips from the rear of the molding (2).

3. Remove the fender flare molding (3) from the fender.

INSTALLATION

MOLDING - FRONT WHEEL OPENING FLARE

Fig. 251: Removing/Installing Fender Flare Molding
Courtesy of CHRYSLER LLC

1. Position and install the front of the molding (1) and the rear of the molding (2) to the fender.

2. Align the front fender molding (3) to the fender assembly and apply enough hand pressure in order to

make sure the clips are fully seated.

1 - Front Flare Clip
2 - Rear Flare Clip
3 - Front Flare Molding

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro

Fig. 252: Removing/Installing Rivets Connecting Fender Flare To Wheel House Liner
Courtesy of CHRYSLER LLC

3. Install four rivets connecting the front fender flare molding to the wheel house liner.

MOLDING - REAR WHEEL OPENING FLARE

REMOVAL

MOLDING - REAR WHEEL OPENING FLARE

Fig. 253: Rear Wheel Flare Molding - Front
Courtesy of CHRYSLER LLC

1 - Door
2 - Rivets
3 - Front Flare Molding

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro

1. Raise and support the vehicle.

2. Open the rear door and remove the rivets (2) from the inside surface of the door (1).

3. Using a trim stick C-4755 or equivalent, separate the clips attaching the molding (3) to the door (1) and

remove the molding.

Fig. 254: Rear Wheel Flare Molding - Rear
Courtesy of CHRYSLER LLC

4. Remove the tire and wheel in order to gain access to the rear wheel flare molding.

5. Remove the rivets (4) attaching the rear flare molding (3) to the body (1) and rear fascia (2).

6. Using a trim stick C-4755 or equivalent, separate the clips attaching the molding (3) to the body (1) and

the rear fascia (2) and remove the molding.

INSTALLATION

MOLDING - REAR WHEEL OPENING FLARE

1 - Body
2 - Rear Fascia
3 - Rear Flare Molding
4 - Rivets

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro