Dodge Nitro. Manual — part 548
Fig. 45: Tilting Inner Race/Hub And Cage And Installing Balls
Courtesy of CHRYSLER LLC
7. Apply lubricant included with replacement boot/joint to the ball races. Spread lubricant equally between
all the races.
8. Tilt inner race/hub (2) and cage (3) and install the balls (4).
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Fig. 46: Pushing Joint Onto Shaft Until Snap Ring Seats In Groove
Courtesy of CHRYSLER LLC
9. Place new clamps onto new boot and slide boot onto the shaft to its original position.
10. Apply the rest of lubricant to the C/V joint and boot.
11. Push the joint onto the shaft until the snap ring (1) seats in the groove (3). Pull on the joint to verify the
span ring has engaged.
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Fig. 47: Securing Both Boot Clamps With Clamp Installer C-4975A
Courtesy of CHRYSLER LLC
12. Position boot on the joint in its original position. Ensure boot is not twisted and remove any excess air.
13. Secure both boot clamps (2) (4) with Clamp Installer C-4975A. Place tool on clamp bridge and tighten
tool until the jaws of the tool are closed.
JOINT/BOOT-C/V INNER
REMOVAL
C/V JOINT-INNER
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Fig. 48: Identifying C/V Joint & Boot
Courtesy of CHRYSLER LLC
1. Clamp shaft in a vise (with soft jaws) and support C/V joint (1).
2. Remove clamps with a cut-off wheel or grinder.
3. Slide boot down (2) the shaft.
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст