Dodge Nitro. Manual — part 875
Fig. 1: Testing Remote Keyless Entry Transmitter
Courtesy of CHRYSLER LLC
DOOR LOCK/UNLOCK SWITCH
REMOVAL
DOOR LOCK/UNLOCK SWITCH
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Power Locks - Service Information - Nitro
Fig. 2: Door Lock/Unlock Switch
Courtesy of CHRYSLER LLC
1. Disconnect and isolate the battery negative cable.
2. Gently pry the switch from the door trim panel.
3. Disconnect electrical harness connector from switch.
INSTALLATION
DOOR LOCK/UNLOCK SWITCH
Fig. 3: Door Lock/Unlock Switch
Courtesy of CHRYSLER LLC
1. Connect the electrical harness connector to the switch.
2. Press the switch into place.
3. Connect the battery negative cable.
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Power Locks - Service Information - Nitro
DOOR LOCK MOTOR
DESCRIPTION
DOOR LOCK MOTOR
The lock mechanisms are actuated by a reversible electric motor mounted within each door and tailgate. The
power lock motors are integral to the door latch units.
The power lock motors cannot be adjusted or repaired and, if faulty or damaged, the door latch unit must be
replaced.
OPERATION
DOOR LOCK MOTOR
The door lock motors are controlled by relays. A positive and negative battery connection to the two motor
terminals will cause the motor to move in one direction. Reversing the current will cause the motor to move in
the opposite direction.
DIAGNOSIS AND TESTING
DOOR LOCK MOTOR
The most reliable, efficient, and accurate means to diagnose the power lock system requires the use of a scan
tool and the proper Diagnostic article. Refer to the appropriate wiring information.
REMOTE KEYLESS ENTRY MODULE
REMOVAL
REMOTE KEYLESS ENTRY MODULE
Refer to REMOVAL .
INSTALLATION
REMOTE KEYLESS ENTRY MODULE
Refer to INSTALLATION .
REMOTE KEYLESS ENTRY TRANSMITTER
DIAGNOSIS AND TESTING
REMOTE KEYLESS ENTRY TRANSMITTER
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Power Locks - Service Information - Nitro
Fig. 4: Remote Keyless Entry Transmitter
Courtesy of CHRYSLER LLC
Using special tool 9001, first test to ensure that the transmitter is functioning. Typical testing distance is 2.5
centimeters (1 inch) for Asian transmitters and 30.5 centimeters (12 inches) for all others. To test, position the
transmitter as shown. Press any transmitter button, then test each button individually. The tool will beep if a
radio signal strength that lights five or more LED's is detected. Repeat this test three times. If transmitter fails
any of the test refer to the Diagnostic article.
STANDARD PROCEDURE
RKE TRANSMITTER CUSTOMER PREFERENCES
AUTOMATIC (ROLLING) LOCKS
The rolling locks feature can be toggled ON/OFF by using the scan tool only.
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Power Locks - Service Information - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст