Dodge Nitro. Manual — part 429
Fig. 338: Removing/Installing Floor Console
Courtesy of CHRYSLER LLC
23. Install the floor console, see INSTALLATION.
Fig. 339: Removing/Installing Fasteners And Close Out Panels
Courtesy of CHRYSLER LLC
24. Install the close out panels and the bolts to the lower I/P and tighten to 2.5 N.m (22 in. lbs.).
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Fig. 340: Instrument Panel, Slots & Moldings
Courtesy of CHRYSLER LLC
25. Align the right and left A-pillar trim tabs on the moldings (3) to the top cover slot of the instrument panel
(1).
26. Align the two clips on the molding to the slots (2) on the A-pillar. Snap the A-pillar trim molding (3) into
place using hand pressure.
27. Connect the negative battery cable to the battery.
STRIKER - GLOVE BOX DOOR LATCH
REMOVAL
STRIKER - GLOVE BOX DOOR LATCH
1. Before proceeding with the following repair procedure, review all warnings and cautions. See
WARNING.
2. Open the glove box.
3. Remove the two striker screws and remove the latch striker.
INSTALLATION
STRIKER - GLOVE BOX DOOR LATCH
1. Before proceeding with the following repair procedure, review all warnings and cautions. See
WARNING.
2. Install the striker and install the two screws.
3. Loosen the screws to adjust if necessary.
INTERIOR
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
BASE - FLOOR CONSOLE
REMOVAL
BASE - FLOOR CONSOLE
Fig. 341: Floor Console Shift Bezel
Courtesy of CHRYSLER LLC
1. Using a trim stick C-4755 or equivalent, pry the shift bezel out of the floor console.
2. If equipped, remove electrical connectors attached to shift bezel.
Fig. 342: Console Lid, End Cap & Electrical Connectors
Courtesy of CHRYSLER LLC
3. Open console lid (1).
4. Using a trim stick C-4755 or equivalent, release the fasteners at the four locations around the floor
console end cap (2).
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
5. Disconnect electrical connectors (3) from end cap (2).
6. Remove end cap (2).
Fig. 343: Removing/Installing Floor Console
Courtesy of CHRYSLER LLC
7. Remove ash cup (3) from console (1).
8. Remove bin (4) from console (1).
9. Remove two screws (2) from front of console (1).
10. Remove two screws (5) from rear of console (1) located inside the console bin.
11. Lift console (1) at back and remove.
INSTALLATION
BASE - FLOOR CONSOLE
Fig. 344: Removing/Installing Floor Console
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст