Dodge Nitro. Manual — part 721
With the scan tool, read DTCs.
Does the scan tool display active: B10B9-CABIN HEATER 2 CONTROL CIRCUIT HIGH?
Yes
Replace the Totally Integrated Power Module (TIPM in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
No
Replace the Cabin Heater Relay 2 in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
B1610-AMBIENT LIGHT SENSOR INPUT CIRCUIT LOW
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
When Monitored:
With the ignition on.
Set Condition:
If the Ambient Light Sensor input is out of range toward the low voltage threshold.
Diagnostic Test
1) VERIFY THE DTC IS ACTIVE
Turn the ignition switch on.
With a scan tool, read and record DTCs.
With the scan tool, clear DTCs.
Turn the ignition switch off, and then on.
Using the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Possible Causes
(L24) AUTO HEADLAMPS SIGNAL CIRCUIT SHORTED TO GROUND
SUNLOAD SENSOR
A/C HEATER CONTROL
2007 Dodge Nitro R/T
2007 HVAC Heating & Air Conditioning - Electrical Diagnostics - Nitro
Yes
Go to 2).
No
The condition that caused this symptom is currently not present. Check for an intermittent
condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken
wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or
contaminated terminals. Repair as necessary.
Perform BODY VERIFICATION TEST - VER 1 .
2) CHECK FOR ACTIVE DTC WITH SUNLOAD SENSOR HARNESS CONNECTOR
DISCONNECTED
Turn the ignition off.
Disconnect the Sunload Sensor harness connector.
Turn the ignition on.
With the scan tool, erase HVAC DTCs.
Turn the ignition off, wait 10 seconds, and turn the ignition on.
With the scan tool, read HVAC DTCs.
Does the scan tool display this DTC as active?
Yes
Go to 3).
No
Replace the Sunload Sensor in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
3) CHECK (L24) AUTO HEADLAMPS SIGNAL CIRCUIT FOR A SHORT TO GROUND
Turn the ignition off.
Disconnect the A/C Heater Control C1 harness connector.
Measure the resistance of the (L24) Auto Headlamps Signal circuit between ground and the A/C Heater
Control C1 harness connector.
Does the ohm meter read open circuit?
2007 Dodge Nitro R/T
2007 HVAC Heating & Air Conditioning - Electrical Diagnostics - Nitro
Yes
Replace the A/C Heater Control in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
No
Repair the (L24) Auto Headlamps Signal circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
B1610-AMBIENT LIGHT SENSOR INPUT CIRCUIT PERFORMANCE
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
When Monitored:
With the ignition on.
Set Condition:
If the Ambient Light Sensor input is out of range.
Diagnostic Test
1) ACTIVE DTC(S) PRESENT
Turn the ignition on.
With the scan tool, check for DTCs.
Does the scan tool display this DTC as active?
Yes
Go to 2).
No
The condition that caused this symptom is currently not present. Check for an intermittent
Possible Causes
(L24) AUTO HEADLAMPS SIGNAL CIRCUIT OPEN
(L24) AUTO HEADLAMPS SIGNAL CIRCUIT SHORTED TO GROUND
(C121) SENSOR GROUND OPEN
SUNLOAD SENSOR
A/C HEATER CONTROL
2007 Dodge Nitro R/T
2007 HVAC Heating & Air Conditioning - Electrical Diagnostics - Nitro
condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken
wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or
contaminated terminals. Repair as necessary.
Perform BODY VERIFICATION TEST - VER 1 .
2) CHECK (L24) AUTO HEADLAMPS SIGNAL CIRCUIT FOR AN OPEN
Turn the ignition off.
Disconnect the A/C Heater Control C1 harness connector.
Disconnect the Sunload Sensor harness connector.
Measure the resistance of the (L24) Auto Headlamps Signal circuit between the Sunload Sensor harness
connector and the A/C Heater Control C1 harness connector.
Does the ohm meter read open circuit?
Yes
Repair the (L24) Auto Headlamps Signal circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .
No
Go to 3).
3) CHECK (L24) AUTO HEADLAMPS SIGNAL CIRCUIT FOR A SHORT TO GROUND
Measure the resistance between ground and the (L24) Auto Headlamps Signal circuit in the A/C Heater
Control C1 harness connector.
Does the ohm meter read open circuit?
Yes
Go to 4).
No
Repair the (L24) Auto Headlamps Signal circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
4) CHECK (C121) SENSOR GROUND CIRCUIT FOR AN OPEN
Measure the resistance of the (C121) Sensor Ground circuit between the Sunload Sensor harness
connector and the A/C Heater Control C1 harness connector.
2007 Dodge Nitro R/T
2007 HVAC Heating & Air Conditioning - Electrical Diagnostics - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст