Dodge Nitro. Manual — part 125
Fig. 227: Installing Crankshaft Damper Using Special Tools C-4685-C1 Bolt With Nut And Thrust
Bearing From 6792, And 6792-1 Installer
Courtesy of CHRYSLER LLC
1. Install crankshaft damper using Special Tools C-4685-C1 (5.9 in.) Bolt, with Nut and Thrust Bearing
from 6792, and 6792-1 Installer.
1 - SPECIAL TOOL 6792-1
2 - SPECIAL TOOL C-4685-C1
2007 Dodge Nitro R/T
2007 ENGINE 4.0L - Service Information - Nitro
Fig. 228: Installing Crankshaft Damper Bolt
Courtesy of CHRYSLER LLC
2. Install crankshaft damper bolt. Torque bolt to 95 N.m (70 ft. lbs.) while holding damper with Special
Tool 9365.
3. Lower vehicle.
2007 Dodge Nitro R/T
2007 ENGINE 4.0L - Service Information - Nitro
Fig. 229: Accessory Drive Belt Routing
Courtesy of CHRYSLER LLC
4. Install accessory drive belt (7).
5. Connect negative battery cable.
ENGINE MOUNTING
DESCRIPTION
ENGINE MOUNTS
The engine mounting system are of molded rubber material and consist of two mounts; right and a left side
support the powertrain, and control powertrain torque.
MOUNT -LEFT
REMOVAL
MOUNT-LEFT
1 - GENERATOR
2 - IDLER PULLEY
3 - WATER PUMP PULLEY
4 - CRANKSHAFT PULLEY
5 - ACCESSORY DRIVE BELT TENSIONER
6 - A/C COMPRESSOR
7 - ACCESSORY DRIVE BELT
2007 Dodge Nitro R/T
2007 ENGINE 4.0L - Service Information - Nitro
Fig. 230: Left Engine Mount
Courtesy of CHRYSLER LLC
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove both engine mount to frame nuts and remove the left engine mount bolts (2).
4. Using a suitable jack and a block of wood under the oil pan, raise the engine until the weight is off of the
mounts (approximately 5mm).
5. Remove the engine mount bolts and remove the mount.
INSTALLATION
MOUNT-LEFT
2007 Dodge Nitro R/T
2007 ENGINE 4.0L - Service Information - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст