Dodge Nitro. Manual — part 914
Fig. 125: Identifying Cooler, Hose Clamps & Mounting Screws
Courtesy of CHRYSLER LLC
1. Install the hose to the vehicle.
2. Install the 3 push pins and install the front fascia into position.
3. Install the hose to the cooler (1) and reclamp (2) with a new hose crimp clamp.
Fig. 126: Identifying Return Hose Assembly & Routing Clip
Courtesy of CHRYSLER LLC
4. Install the return hose assembly routing clip (1).
Fig. 127: Identifying Reservoir & Return Hose
Courtesy of CHRYSLER LLC
5. Install a new hose clamp for the cooler to reservoir hose (2) to the reservoir (1).
6. Lower the vehicle.
2007 Dodge Nitro R/T
2007 STEERING Steering System - Nitro
7. Fill and bleed power steering system. See STANDARD PROCEDURE.
8. Inspect for leaks.
PRESSURE HOSE - DIESEL
Fig. 128: Identifying Pressure Line, Pump, Bracket Bolts & Gear
Courtesy of CHRYSLER LLC
1. Install the pressure hose (1) to the vehicle.
2. Install the pressure hose mounting bracket bolts (3) to the frame.
3. Install the pressure hose at the gear (4).
4. Install the pressure line (1) at the pump (2).
5. Install the airbox. Refer to INSTALLATION .
6. Refill the power steering fluid.
7. Bleed the power steering system. See STANDARD PROCEDURE.
8. Check for leaks.
PULLEY
REMOVAL
PULLEY- GAS ENGINE
2007 Dodge Nitro R/T
2007 STEERING Steering System - Nitro
Fig. 129: Removing Pulley
Courtesy of CHRYSLER LLC
1. Remove air cleaner housing. Refer to REMOVAL .
2. Remove the washer/coolant reservoir assembly.
3. Remove the fan shroud.
4. Remove power steering belt. Refer to REMOVAL .
5. Remove the pulley (2) from the pump using (OTC® 7185) power steering pulley removal tool or
equivalent (3).
PULLEY - DIESEL ENGINE
CAUTION: Do not reuse the old power steering pump pulley it is not intended for
reuse. A new pulley must be installed if removed.
2007 Dodge Nitro R/T
2007 STEERING Steering System - Nitro
Fig. 130: Identifying Pulley, Serpentine Drive Belt, Bolts & Pump
Courtesy of CHRYSLER LLC
1. Remove the air cleaner box. Refer to REMOVAL .
2. Remove the air inlet tube.
3. Remove the serpentine drive belt (2).
4. Remove the three bolts (3) securing the pulley (1) to the pump (4).
INSTALLATION
PULLEY - DIESEL ENGINE
Fig. 131: Identifying Pulley, Serpentine Drive Belt, Bolts & Pump
Courtesy of CHRYSLER LLC
1. Install the pulley (1) to the pump shaft.
2. Install the three bolts (3) securing the pulley (1) to the pump (4). Tighten to 47 N.m (35 ft. lbs.).
2007 Dodge Nitro R/T
2007 STEERING Steering System - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст