Dodge Nitro. Manual — part 164
Turn the ignition off.
Disconnect the Anti-Lock Brake Module harness connector.
Using a 12-volt test light connected to 12-volts, probe the (B3) Left Rear WSS Signal circuit.
Does the test light illuminate brightly?
Yes
Repair the (B3) Left Rear WSS Signal circuit for a short to ground.
Perform ABS VERIFICATION TEST.
No
Go to 7).
7) CHECK (B3) LEFT REAR WSS SIGNAL CIRCUIT FOR AN OPEN
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Fig. 26: Probing (B3) Left Rear WSS Signal Circuit
Courtesy of CHRYSLER LLC
Connect a jumper wire between ground and the (B3) Left Rear WSS Signal circuit in the Anti-Lock
Brakes Module harness connector.
Using a 12-volt test light connected to 12-volts, probe the (B3) Left Rear WSS Signal circuit.
Does the test light illuminate brightly?
Yes
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Go to 8).
No
Repair the (B3) Left Rear WSS Signal circuit for an open.
Perform ABS VERIFICATION TEST.
8) CHECK (B3) LEFT REAR WSS SIGNAL CIRCUIT SHORT TO VOLTAGE
Fig. 27: Measuring Voltage Between (B3) Left Rear WSS Signal Circuit And Ground
Courtesy of CHRYSLER LLC
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Turn the ignition on.
Remove all jumper wires.
Measure the voltage between the (B3) Left Rear WSS Signal circuit and ground.
Is the voltage above one volt?
Yes
Repair the (B3) Left Rear WSS Signal circuit for a short to voltage.
Perform ABS VERIFICATION TEST.
No
Go to 9).
9) CHECK (B3) LEFT REAR WSS SIGNAL CIRCUIT AND (B4) LEFT REAR WSS 12 VOLT
SUPPLY CIRCUIT SHORTED TOGETHER
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст