Dodge Nitro. Manual — part 444

1. Using a trim stick C-4755 or equivalent, remove the headliner molding.

2. For the upper lift gate adjustments, loosen the hinge nuts (2) and bolts (3) but do not remove. Adjust to

specifications, see SPECIFICATIONS.

3. Apply body sealer on the hinge to body mating surface.

4. Tighten the hinge bolts to 28.5 N.m (21 ft. lbs.).

5. Tighten the hinge nuts to 28.5 N.m (21 ft. lbs.).

Fig. 432: Lift Gate Latch Striker
Courtesy of CHRYSLER LLC

6. Remove the rear door scuff plate.

7. For the lower lift gate adjustments, loosen the striker screws (2) and adjust to specifications, see

SPECIFICATIONS.

8. Tighten the striker screws to 28 N.m (20.5 ft. lbs.).

9. Install the rear door scuff plate.

10. Position the headliner molding and seat fully.

Up/Down and Left/Right

NOTE:

The position of the lift gate can be adjusted upward or downward by the use of
slots in the hinge. An inward or outward adjustment is achieved by use of slots
in the body. If an inward or outward adjustment is needed, use a body sealer on
the hinge to body mating surface.

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro

Fig. 433: Lift Gate/Hinge
Courtesy of CHRYSLER LLC

1. Loosen the hinge to lift gate bolts (2) but do not remove.

Fig. 434: Lift Gate Latch Striker
Courtesy of CHRYSLER LLC

2. Remove the rear door scuff plate.

3. Loosen the striker screws (2).

4. Adjust the lift gate up/down position to specifications, see SPECIFICATIONS.

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro

Fig. 435: Lift Gate/Hinge
Courtesy of CHRYSLER LLC

5. Apply body sealer on the hinge to lift gate mating surface.

6. Tighten the hinge to lift gate bolts to 28.5 N.m (21 ft. lbs.).

Fig. 436: Lift Gate Latch Striker
Courtesy of CHRYSLER LLC

7. Confirm the lower lift gate in/out position and tighten the striker screws to 28 N.m (20.5 ft. lbs.).

8. Install the lift gate trim scuff plate and install the screws.

PANEL - LIFTGATE TRIM

REMOVAL

PANEL - LIFTGATE TRIM

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro

Fig. 437: Liftgate Trim Panel
Courtesy of CHRYSLER LLC

1. Remove two bolts (2) from the lower trim panel (3).

2. Using a trim stick C-4755 or equivalent, release the fasteners at all of the locations around the trim panel

(3).

3. Lift the trim panel (3) from the lift gate (1).

INSTALLATION

PANEL - LIFTGATE TRIM

Fig. 438: Liftgate Trim Panel
Courtesy of CHRYSLER LLC

1. Align and install the trim panel (3) to the lift gate (1), use hand pressure to seat all of the fasteners around

the trim panel (3).

2. Install the two bolts (2) to the lower trim panel (3) and tighten to 7 N.m (65 in. lbs.).

2007 Dodge Nitro R/T

2007 ACCESSORIES AND EQUIPMENT Body - Nitro