Dodge Nitro. Manual — part 312
Fig. 28: Installing Low/Reverse Clutch Snap Ring
Courtesy of CHRYSLER LLC
11. Install snap ring (1) and remove compressor tool. See Fig. 28
1 - SNAP RING OPENING MUST BE BETWEEN SPRING
LEVERS (AS SHOWN)
2 - SNAP RING PLIERS
3 - DISC 6057
2007 Dodge Nitro R/T
2007 AUTOMATIC TRANSMISSION 42RLE - Service Information - Nitro
2007 Dodge Nitro R/T
2007 AUTOMATIC TRANSMISSION 42RLE - Service Information - Nitro
Fig. 29: Installing Rear Carrier Front Bearing Cone
Courtesy of CHRYSLER LLC
12. Install rear carrier (4) front bearing cone. See Fig. 29
Fig. 30: Installing Rear Output Shaft Bearing Cone And Support Plate 6618A
Courtesy of CHRYSLER LLC
Check output bearing preload. Output bearing preload must be checked and/or adjusted if any of the
following items have been replaced:
Output shaft (rear carrier assembly)
Output shaft bearings
1 - ARBOR PRESS
2 - UNIVERSAL HANDLE C-4171
3 - INSTALLER 6052
4 - REAR CARRIER
1 - SUPPORT PLATE 6618-A
2 - REAR OUTPUT SHAFT BEARING
2007 Dodge Nitro R/T
2007 AUTOMATIC TRANSMISSION 42RLE - Service Information - Nitro
Transmission case
13. PRELOAD CHECK/SHIM SELECTION: Install rear output shaft bearing cone and Support Plate
6618A (1). See Fig. 30.
Fig. 31: Installing Support Plate
Courtesy of CHRYSLER LLC
14. Install Support Plate 6618A (1). See Fig. 31. Lightly tighten retaining screws. Screws should be below
the plate surface, but do not snug screws.
15. Turn case over on arbor press so that the plate is resting on the press base. CAUTION: The output shaft
will extend through the hole of Support Plate 6618A. Ensure your press table has clearance for the
output shaft.
1 - SUPPORT PLATE 6618-A
2007 Dodge Nitro R/T
2007 AUTOMATIC TRANSMISSION 42RLE - Service Information - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст