Dodge Viper SRT-10 (ZB). Manual — part 322
Symptom:
*PASSENGER DOOR AJAR CIRCUIT OPEN
POSSIBLE CAUSES
PASSENGER DOOR AJAR SWITCH GROUND CIRCUIT OPEN
PASSENGER DOOR AJAR SWITCH
PASSENGER DOOR AJAR SWITCH SENSE CIRCUIT OPEN
BODY CONTROL MODULE - PASSENGER DOOR AJAR OPEN
TEST
ACTION
APPLICABILITY
1
Disconnect the Passenger Door Ajar switch connector.
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit.
Does the light illuminate?
All
Yes
→ Go To 2
No
→ Repair the Passenger Door Ajar Switch Ground circuit for an
open.
Perform BODY VERIFICATION TEST - VER 1.
2
Disconnect the Passenger Door Ajar Switch connector.
Connect a jumper wire between the Sense circuit and the Ground circuit.
With the DRBIII
t in Inputs/Outputs, read the PASS DOOR AJAR SW state.
Does the DRBIII
t display CLOSED?
All
Yes
→ Replace the Passenger Door Ajar Switch.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 3
3
Disconnect the Passenger Door Ajar Switch connector.
Disconnect the BCM C3 connector.
Measure the resistance of the Sense circuit between the BCM C3 connector and the
Door Ajar Switch connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 4
No
→ Repair the Passenger Door Ajar Switch Sense circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
4
If there are no possible causes remaining, view repair.
All
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
181
DOOR AJAR
Symptom:
*PASSENGER DOOR AJAR CIRCUIT SHORTED TO GROUND
POSSIBLE CAUSES
PASSENGER DOOR AJAR SWITCH SHORTED TO GROUND
PASSENGER DOOR AJAR SWITCH SENSE CIRCUIT SHORTED TO GROUND
BODY CONTROL MODULE - PASSENGER DOOR AJAR SHORTED
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t in Inputs/Outputs, read the PASS DOOR AJAR SW state.
While monitoring the DRBIII
t, disconnect the Passenger Door Ajar Switch connector.
Did the Switch State change from CLOSED to OPEN?
All
Yes
→ Replace the Passenger Door Ajar Switch.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 2
2
Disconnect the Passenger Door Ajar Switch connector.
Disconnect the BCM C3 harness connector.
Using a 12-volt test light connected to 12-volts, probe the Sense circuit and test for
a short to ground.
Does the test light illuminate?
All
Yes
→ Repair the Passenger Door Ajar Switch Sense circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 3
3
If there are no possible causes remaining, view repair.
All
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
182
DOOR AJAR
Symptom:
DEFOG RELAY CONTROL CKT SHORTED TO BATT
When Monitored and Set Condition:
DEFOG RELAY CONTROL CKT SHORTED TO BATT
When Monitored:
With the ignition on and the EBL switch depressed.
Set Condition:
This DTC will set when the A/C Heater Control Module senses excessive
current draw on the Rear Window Defogger Relay Control Circuit.
POSSIBLE CAUSES
CHECK FOR HVAC DTC’S
REAR WINDOW DEFOGGER RELAY SHORTED TO BATTERY
REAR WINDOW DEFOGGER RELAY CONTROL CKT SHORTED TO BATTERY
A/C HEATER CONTROL MODULE
TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
With the DRBIII
t, record and erase DTC’s.
Depress the EBL switch on the A/C Heater Control Module.
With the DRBIII
t, read the active DTC’s.
Does the DRBIII
t display DEFOG RELAY CONTROL CKT SHORTED TO BATT?
All
Yes
→ Go To 2
No
→ Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors. Refer to any Hotline letters or Technical
Service Bulletins that may apply.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition on.
With the DRBIII
t, record and erase DTC’s.
Turn the ignition off.
Remove and install a known good relay in place of the Rear Window Defogger Relay.
Turn the ignition on.
Depress the EBL Switch on the A/C Heater Control Module.
With the DRBIII
t, read the active DTC’s.
Does the DRBIII
t display DEFOG RELAY CONTROL CKT SHORTED TO BATT?
All
Yes
→ Go To 3
No
→ Replace the Rear Window Defogger Relay in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
183
ELECTRICALLY HEATED SYSTEMS
TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Remove the Rear Window Defogger Relay from the Power Distribution Center.
Disconnect the A/C Heater Control Module C2 harness connector.
Measure the voltage of the Rear Window Defogger Relay Control circuit at the A/C
Heater Control Module connector with the Ignition off and on.
Is there any voltage present?
All
Yes
→ Repair the Rear Window Defogger Relay Control circuit for a
short to battery.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the A/C Heater Control Module in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
184
ELECTRICALLY HEATED SYSTEMS
DEFOG RELAY CONTROL CKT SHORTED TO BATT —
Continued
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст