Dodge Viper SRT-10 (ZB). Manual — part 4

The 5 Year/100,000 Mile Formula (orange in color)

and the Three Year Formula (green in color) MUST
NOT BE MIXED.

CAUTION:

Mopar

T

Antifreeze/Coolant,

5

Year/100,000 Mile Formula (MS-9769) may not be
mixed with any other type of antifreeze. Doing so
will reduce the corrosion protection and may result
in premature water pump seal failure. If non-HOAT
coolant is introduced into the cooling system in an
emergency, it should be replaced with the specified
coolant as soon as possible.

AXLE

NOTE: DaimlerChrysler recommends using Mopar

T

lubricants or lubricants of equal quality.

• 226RIA - Mopart Synthetic Gear & Axle Lubri-

cant 75W-140, plus 4 ounces of Mopar

t Limited Slip

Additive

POWER STEERING FLUID

The power steering fluid recommended is Mopar

t

Power Steering Fluid MS 5931. Transmission fluid
should not be used in the power steering.

MANUAL TRANSMISSION

NOTE: DaimlerChrysler recommends using Mopar

T

lubricants or lubricants of equal quality.

• Tremec T-56 - Mopart Synthetic 75W85 Manual

Transmission Lubricant

FLUID CAPACITIES

SPECIFICATIONS

FLUID CAPACITIES

DESCRIPTION

SPECIFICATION

Fuel Tank

70.0 L (18.5 gal.)

Engine Oil with Oil Filter

10.4 L (11.0 qts.)

Cooling System

15.1 L (16.0 qts.)

Transmission

3.8 L (4 qts.)

Differential Including

Additive

1.35 L (45 oz.)

Differential Additive

0.1 L (4 oz.)

Brake Fluid

0.3 L (7.5 oz.)

Windshield Washer

1 L (1 qt.)

FLUID CAPACITIES - EXPORT

DESCRIPTION

SPECIFICATION

Fuel Tank

70.0 L (18.5 gal.)

Engine Oil with Oil Filter

10.4 L (11.0 qts.)

Cooling System

15.1 L (16.0 qts.)

Transmission

3.8 L (4 qts.)

Differential Including

Additive

1.35 L (45 oz.)

Differential Additive

0.1 L (4 oz.)

Brake Fluid

0.3 L (7.5 oz.)

Windshield Washer

4.7 L (5 qts.)

FLUID FILL/CHECK
LOCATIONS

DESCRIPTION

The fluid check/fill point locations are located in

each applicable service manual section.

LUBRICATION POINTS

DESCRIPTION

Lubrication point locations are located in each

applicable Sections.

MAINTENANCE SCHEDULES

DESCRIPTION

MAINTENANCE SCHEDULES

There are two maintenance schedules that show

the required service for your vehicle.

First is Schedule “B”. It is for vehicles that are

operated under the conditions that are listed below
and at the beginning of the schedule.

• Day or night temperatures are below 32° F (0°

C).

• Stop and go driving.

• Extensive engine idling.

• Driving in dusty conditions.

• Short trips of less than 10 miles (16 km).

• More than 50% of your driving is at sustained

high speeds during hot weather, above 90° F (32° C).

• Trailer towing.L

• Taxi, police, or delivery service (commercial ser-

vice).

L

• Off-road or desert operation.

0 - 4

LUBRICATION & MAINTENANCE

ZB

FLUID TYPES (Continued)

• If equipped for and operating with E-85

(ethanol) fuel.

NOTE: If ANY of these apply to you then change
your engine oil every 3,000 miles (5,000 km) or 3
months, whichever comes first and follow schedule
B of the “Maintenance Schedules” section of this
manual.

NOTE: If ANY of these apply to you then flush and
replace the engine coolant every 102,000 miles
(164,000 km) or 60 months, whichever comes first,
and follow schedule B of the

(

Maintenance Sched-

ules

(

section of this manual.

NOTE: Most vehicles are operated under the condi-
tions listed for Schedule

(

B

(

.

Second is Schedule “A”. It is for vehicles that are

not operated under any of the conditions listed under
Schedule

9B9.

Use the schedule that best describes your driving

conditions. Where time and mileage are listed, follow
the interval that occurs first.

NOTE: Under no circumstances should oil change
intervals exceed 6 months or 6,000 miles, which-
ever comes first.

CAUTION: Failure to perform the required mainte-
nance items may result in damage to the vehicle.

At Each Stop for Fuel

• Check the engine oil level about 5 minutes after

a fully warmed engine is shut off. Checking the oil
level while the vehicle is on level ground will
improve the accuracy of the oil level reading. Add oil
only when the level is at or below the ADD or MIN
mark.

• Check the windshield washer solvent and add if

required.

Once a Month

• Check tire pressure and look for unusual wear

or damage.

• Inspect the battery and clean and tighten the

terminals as required.

• Check the fluid levels of coolant reservoir, brake

master cylinder, power steering and transmission
and add as needed.

• Check all lights and all other electrical items for

correct operation.

At Each Oil Change

• Change the engine oil filter.

• Inspect the exhaust system.

• Inspect the brake hoses.

• Inspect the suspension components.

• Lubricate door hinges and check springs.

• Check the engine coolant level, hoses, and

clamps.

• Check power steering fluid level.

SCHEDULE B

Follow schedule “B” if you usually operate your

vehicle under one or more of the following conditions.

• Day or night temperatures are below 32° F (0°

C).

• Stop and go driving.

• Extensive engine idling.

• Driving in dusty conditions.

• Short trips of less than 10 miles (16 km).

• More than 50% of your driving is at sustained

high speeds during hot weather, above 90° F (32° C).

• Trailer towing.

• Taxi, police, or delivery service (commercial ser-

vice).

• Off-road or desert operation.

• If equipped for and operating with E-85

(ethanol) fuel.

NOTE: If ANY of these apply to you then change
your engine oil every 3,000 miles (5 000 km) or 3
months, whichever comes first and follow schedule
“B” of the

(

Maintenance Schedules

(

section of this

manual.

NOTE: IF ANY of these apply to you then flush and
replace the engine coolant every 102,000 miles
(164,000 km) or 60 months, whichever comes first,
and follow schedule B of the

(

Maintenance Sched-

ules

(

section of this manual.

ZB

LUBRICATION & MAINTENANCE

0 - 5

MAINTENANCE SCHEDULES (Continued)

Miles

3,000

6,000

9,000

12,000

15,000

18,000

(Kilometers)

(5 000)

(10 000)

(14 000)

(19 000)

(24 000)

(29 000)

Change engine oil and engine oil filter, if
not replaced at 3 months.

X

X

X

X

X

X

Inspect the brake linings.

X

Change the rear axle fluid.

X

Inspect and replace, if necessary, the air
cleaner filter.

X

Lubricate the front and rear suspension
ball joints.

X

Miles

21,000

24,000

27,000

30,000

33,000

36,000

(Kilometers)

(34 000)

(38 000)

(43 000)

(48 000)

(53 000)

(58 000)

Change engine oil and engine oil filter, if
not replaced at 3 months.

X

X

X

X

X

X

Lubricate the front and rear suspension
ball joints.

X

Inspect the brake linings.

X

X

Change the rear axle fluid.

X

X

Inspect and replace, if necessary, the air
cleaner filter.

X

Replace the spark plugs.

X

Change the transmission fluid.

X

Inspect and replace, if necessary, the
PCV orifice. *

X

Change the brake and clutch fluid.

X

Miles

39,000

42,000

45,000

48,000

51,000

54,000

(Kilometers)

(62 000)

(67 000)

(72 000)

(77 000)

(82 000)

(86 000)

Change engine oil and engine oil filter, if
not replaced at 3 months.

X

X

X

X

X

X

Lubricate the front and rear suspension
ball joints.

X

Inspect the brake linings.

X

Inspect and replace, if necessary, the
engine air cleaner filter.

X

Change the transmission fluid.

X

Change the rear axle fluid.

X

0 - 6

LUBRICATION & MAINTENANCE

ZB

MAINTENANCE SCHEDULES (Continued)

Miles

57,000

60,000

63,000

66,000

69,000

72,000

(Kilometers)

(91 000)

(96 000)

(101 000)

(106 000)

(110 000)

(115 000)

Change engine oil and engine oil
filter, if not replaced at 3 months.

X

X

X

X

X

X

Lubricate the front and rear sus-
pension ball joints.

X

Change the rear axle fluid.

X

X

Inspect the brake linings.

X

X

Inspect and replace, if neces-
sary, the air cleaner filter.

X

Replace the spark plugs.

X

Replace the ignition cables.

X

Inspect and replace, if neces-
sary, the PCV orifice. *

X

Inspect and replace the Auto
Tension Drive Belt as needed.

X

Change the brake and clutch
fluid.

X

Change the transmission fluid.

X

Flush and replace engine coolant
at 60 months, if not done at
102,000 miles.

X

Miles

75,000

78,000

81,000

84,000

87,000

90,000

(Kilometers)

(120 000)

(125 000)

(130 000)

(134 000)

(139 000)

(144 000)

Change engine oil and engine oil
filter, if not replaced at 3 months.

X

X

X

X

X

X

Lubricate the front and rear sus-
pension ball joints.

X

X

Inspect the brake linings.

X

Change the rear axle fluid.

X

Inspect and replace, if neces-
sary, the air cleaner filter.

X

X

Replace the spark plugs.

X

Change the brake and clutch
fluid.

X

Inspect and replace, if neces-
sary, the PCV orifice. *

X

Inspect and replace the Auto
Tension Drive Belt as needed. ‡

X

X

Change the transmission fluid.

X

ZB

LUBRICATION & MAINTENANCE

0 - 7

MAINTENANCE SCHEDULES (Continued)