Lifan 620. Manual — part 62
Table 4-15
Testing
terminal
Wire
color
Terminal description
Test condition
Standard
value
1-body B/U
High-speed power output of wiper
motor
Ignition switch ON; the right
combination switch is at
high-speed wiping position,
always
10~14V
Ignition switch ON; the right
2
U
Power input of wiper motor
Ignition switch is at
ACC, always
10~14V
3
Y/G
Return signal of wiper motor
Motor returns to the
end, always
<
1Ω
4
B/U
High-speed input of wiper motor
4 (+) 5 (-), always
Motor runs at high speed
5
B
Motor ground signal
Always
<
1Ω
249
Fig. 4-99
Table 4-17
Fig. 4-100
250
IV. Fault Table of Wiper and Washer System
(as shown in Table 4-18)
Table 4-18
Fault
Cause
Fault
Cause
Inactive wiper and
washer
1 Fault in accessory relay
2 Fault in wiper fuse
3 Fault in wiper
combination switch
assembly
Inactive wiper at LO
or HI
1 Fault in wiper combination
switch assembly
2 Fault in wiper motor
3 Fault in wiring
Fig. 4-101
251
Check the conductivity between terminals of wiper connector of the wiper combination switch
①
assembly. When the wiper is at MIST, the terminal 2 and terminal 11 should be conducted. When
at OFF, terminal 2 and terminal 10 should be conducted; when at INT, terminal 2 and terminal 10
should be conducted as well as terminal 2 and terminal 11; when at LO, terminal 2 and terminal 11
should be conducted; when at HI, terminal 11 and terminal 1 should be conducted.
Check the conductivity between terminals of was
②
her connector of the wiper combination switch
Fig. 4-102
252
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст