Lifan 620. Manual — part 32
(2) Discharge the air and turn the steering wheel for several times to raise the fluid temperature to
50-60 .
℃
Fig. 2-38
1. Lower steering shaft 2. Bolt
3. Acoustic hood on the steering gear 4. Oil pipeline connector of steering gear
5. Bolt 6. Steering gear assembly
7. Sub-frame
(1) Removal
129
Discharge steering fluid.
①
②
Dismantle the high pressure oil outlet pipe connected to the steering oil pump, screw off the
hollow bolt, and remove the hose bracket connected to the engine.
Disconnect the steering gear from the steering lower shaft.
③
④
Dismantle the connectors between steering gear and the return oil pipeline, and remove the
front sub-frame and steering assembly from the vehicle body.
⑤
Dismantle the steering gear assembly from the front sub-frame.
(2) Inspection of the power steering gear
Note:
The internal components of the steering gear can not be disassembled, but replaced or
②
③
④
①
②
130
Section III Brake System
With air in system
Discharge the air in system.
Braking master pump
Check the braking master pump.
Brake disc
Check and install a new component if necessary.
Rapidly sunken
pedal
Brake pad
Check and install a new component if necessary.
Brake caliper
Check and install a new component if necessary.
Slowly sunken pedal
Brake master pump
Check the brake master pump.
131
Table 2-4
Fault Possible
Cause
Actions
With air in system
Discharge the air in system.
Brake pad
Check and install a new component if necessary.
Low-position or soft pedal
Brake booster
Check the booster components.
Brake pad
Check and install a new component if necessary.
Brake disc
Check and install a new component if necessary.
Locked pedal when gently
stepping down the pedal
Brake booster
Check the booster components.
travel
Fig. 2-39
1. Refill brake fluid into the reservoir (as shown in Fig. 2-39)
132
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст