Lifan 620. Manual — part 42
The use conditions are:
1) Speed is less than 2 km/h;
2) Not connected to fault diagnostic instrument;
3) Wire L (pin 7 in the internal diagnosis interface) is always grounded during diagnosis.
Besides, restore ECU mode of ABS to normal mode (diagnosis mode before) after DTC read.
Method: after diagnosis, disconnect wire L from ground, turn the key to off-power condition, and
connect again.
(2) Method of DTC read without fault diagnostic instrument
Read in the following steps if meeting the conditions of DTC read without fault diagnostic
T1
Symbol of diagnosis start; warning lamp flickers
3.0s
T2
Interval of different DTC
3.0s
T3
Warning lamp flash interval in case of DTC
0.5s
T4
Interval of different digital place of a DTC (the ten’s place
is displayed before the interval and the unit’s place is
after the interval)
1.5s
Take the procedure illustrated in Fig. 3-16 for example. In the display area of the first DTC, as
warning lamp blinks twice (each on and off is T3, 0.5 second) before T4 (1.5 seconds before
warning lamp is turned on), the first mark (ten’s place) of the 2 digital code is 2; as warning lamp
169
blinks once after T4 (1.5 seconds after warning lamp is turned off), the second mark of the 2 digital
code (unit’s place) is 1; as then warning lamp is turned off for 3 seconds (T2), the display of the
first DTC is finished, and the DTC is 21. Detailed description of the fault can be found in the DTC
Table of Section 2.4. It is the same with DTC 22.
(3) Deletion of DTC without fault diagnostic instrument
After DTC read and fault elimination according to DTC Table, previous DTC should be deleted
before next DTC check. The conditions of DTC deletion are the same with that of DTC read, as
shown in Fig. 3-17.
symbols are the same with that above.
Fig. 3-18
170
4. DTC Table
(1) DTC content is in Table 3-8.
(2) See Table3-9, Table 3-10, Table 3-11, Table 3-12, Table 3-13, Table 3-14 and Table 3-15 for
DTC Table.
Table 3-8
DTC Content
DTC
Content
C1 200
Left front sensor open/short circuit
C1 206
Left rear sensor open/short circuit
C1 201
Left front sensor or gear ring disturbance
C1 207
Left rear sensor or gear ring disturbance
procedure
171
Table 3-9 (continued)
172
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст