Infiniti M35/M45 Y50. Manual — part 179



DIAGNOSIS SYSTEM

AV-93

[WITHOUT MOBILE ENTERTAINMENT SYSTEM]

C

D

E

F

G

H

I

J

L

M

A

B

AV

NAVIGATION
Steering Angle Adjustment

The steering angle output value detected with the gyroscope can be
adjusted.

Speed Calibration

Usually the automatic distance correction function adjusts the mal-
function in distance caused by the tires wearing down or the tire
pressure change. If prompt adjustment is necessary when the tire
chains are installed etc., perform this procedure.

ERROR HISTORY

The diagnostic results of “Self-diagnosis” determine if any malfunction occurred between selecting “Self-diag-
nosis” and displaying “Self-diagnostic Results”.
If an error occurred before the ignition switch was turned ON and does not occur again until “Self-diagnosis” is
completed, the trouble diagnosis result will be judged normal. Therefore, errors in the past which cannot be
found by “Self-diagnosis”, must be found by checking the “Error record”.
The error history shows the error occurrence frequency in past. The frequency of occurrence is displayed by 2
types: the count down type and the count up type. Select either type according to the error item.
In “Error History” of models with NAVI, time and place that the selected error last occurred are displayed. Be
careful about the following.

If there is a malfunction with the GPS antenna circuit board in the NAVI control unit, the correct date of
occurrence may not be able to be displayed.

Place of the error occurrence is represented by the position of the current location mark at the time an
error occurred. If current location mark has deviated from the correct position, then the place of the error
occurrence cannot be located correctly.

Transition Screen

Without NAVI

SKIB3684E

SKIB3685E

SKIB3665E

AV-94

[WITHOUT MOBILE ENTERTAINMENT SYSTEM]

DIAGNOSIS SYSTEM

With NAVI

Count Down Type

When the error is detected, set the counter to 40. If the system is normal when turning the ignition switch
ON, the counter decreases by 1.

The lower limit of the counter is 1. It can be reset to 0 by “Delete log” switch or CONSULT-II.

Count Up Type

When the ignition switch is turned ON if the error is detected, the counter increases 1. Even if it is normal
when the ignition switch is turned ON the next time, the counter does not decrease.

The upper limit of the counter is 50. 51 or more is displayed as 50. It can be reset to 0 by “Delete log”
switch or CONSULT-II.

Error Item

Some error items may be displayed simultaneously according to the cause. If some error items are displayed
simultaneously, the detection of the cause can be performed by the combination of display items

SKIB3687E

Display type of occur-

rence frequency

Error history display item

Count down type

CAN_COMM_CIRCUIT, CONTROL UNIT (CAN), AV COMM CIRCUIT, CONTROL UNIT (AV)

Count up type

Other than the above

Error item

Description

Possible cause/Action to take

CAN_COMM_CIRCUIT

CAN communication malfunction is
detected

Perform the diagnosis using CONSULT-II,
and then repair the malfunctioning parts
based on diagnostic results.
Refer to

AV-103, "SELF-DIAG RESULTS"

.

CONTROL UNIT (CAN)

CAN initial diagnosis malfunction is
detected

Replace AV (NAVI) control unit
Refer to

AV-131, "AV (NAVI) Control Unit"

CONTROL UNIT (AV)

AV communication circuit initial diagno-
sis malfunction is detected

Replace AV (NAVI) control unit
Refer to

AV-131, "AV (NAVI) Control Unit"

AV COMM CIRCUIT

Switches Connection Error

DVD Deck Connection Error

Audio Unit Connection Error

Amplifier Connection Error

Rearview Camera Connection Error

Malfunction is detected on communi-
cation circuit between AV (NAVI) con-
trol unit and DVD player

Communication circuit between AV
(NAVI) control unit and DVD player

AV (NAVI) control unit

DVD player

DIAGNOSIS SYSTEM

AV-95

[WITHOUT MOBILE ENTERTAINMENT SYSTEM]

C

D

E

F

G

H

I

J

L

M

A

B

AV

AV COMM CIRCUIT

Switches Connection Error

Audio Unit Connection Error

Amplifier Connection Error

Rearview Camera Connection Error

BOSE surround 5.1ch system

Malfunction is detected on communi-
cation circuit between DVD player
and multifunction switch

Communication circuit between DVD
player and multifunction switch

DVD player

Multifunction switch

BOSE 2ch system

Malfunction is detected on communi-
cation circuit between AV (NAVI)
control unit and multifunction switch

Communication circuit between AV
(NAVI) control unit and multifunction
switch

AV (NAVI) control unit

Multifunction switch

AV COMM CIRCUIT

Audio Unit Connection Error

Amplifier Connection Error

Rearview Camera Connection Error

Malfunction is detected on communi-
cation circuit between multifunction
switch and camera control unit

Communication circuit between multi-
function switch and camera control unit

Multifunction switch

Camera control unit

AV COMM CIRCUIT

Audio Unit Connection Error

Amplifier Connection Error

Base system

Audio unit power supply and ground
circuit malfunction is detected

Malfunction is detected on communi-
cation circuit between multifunction
switch and audio unit

Malfunction is detected on communi-
cation signal between audio unit and
AV (NAVI) control unit

Audio unit power supply and ground cir-
cuit

Communication circuit between multi-
function switch and audio unit

Multifunction switch

Audio unit

AV (NAVI) control unit

BOSE system

Malfunction is detected on communi-
cation circuit between camera con-
trol unit and BOSE amp

Communication circuit between camera
control unit and BOSE amp

Camera control unit

BOSE amp

AV COMM CIRCUIT

Audio Unit Connection Error

Audio unit power supply and ground
circuit malfunction is detected

Malfunction is detected on communi-
cation circuit between BOSE amp
and audio unit

Malfunction is detected on communi-
cation signal between audio unit and
AV (NAVI) control unit

Audio unit power supply and ground cir-
cuit

Communication circuit between BOSE
amp and audio unit

Audio unit

AV (NAVI) control unit

BOSE amp

AV COMM CIRCUIT

Rearview Camera Connection Error

Camera control unit power supply
and ground circuit malfunction is
detected

Malfunction is detected on communi-
cation signal between camera con-
trol unit and AV (NAVI) control unit

Camera control unit power supply and
ground circuit

Camera control unit

AV (NAVI) control unit

AV COMM CIRCUIT

Switches Connection Error

Multifunction switch power supply
and ground circuit malfunction is
detected

Malfunction is detected on communi-
cation signal between multifunction
switch and AV (NAVI) control unit

Multifunction switch power supply and
ground circuit

Multifunction switch

AV (NAVI) control unit

AV COMM CIRCUIT

DVD Deck Connection Error

DVD player power supply and
ground circuit malfunction is
detected

Malfunction is detected on communi-
cation signal between DVD player
and AV (NAVI) control unit

DVD player power supply and ground
circuit

DVD player

AV (NAVI) control unit

Error item

Description

Possible cause/Action to take

AV-96

[WITHOUT MOBILE ENTERTAINMENT SYSTEM]

DIAGNOSIS SYSTEM

AV COMM CIRCUIT

Amplifier Connection Error

BOSE amp power supply and
ground circuit malfunction is
detected

Malfunction is detected on communi-
cation signal between BOSE amp
and AV (NAVI) control unit

BOSE amp power supply and ground
circuit

BOSE amp

AV (NAVI) control unit

Front Display Connection Error

Front display unit power supply and
ground circuit malfunction is
detected

Malfunction is detected on communi-
cation circuit between front display
unit and AV (NAVI) control unit

Malfunction is detected on communi-
cation signal between front display
unit and AV (NAVI) control unit

Front display unit power supply and
ground

Communication circuit between front
display unit and AV (NAVI) control unit

Front display unit

AV (NAVI) control unit

GPS Antenna Error

GPS antenna connection malfunction
is detected

GPS antenna feeder

GPS antenna

NAVI control unit

Camera Control Unit Connection Error

Camera and connection recognition
signal circuit malfunction is detected

Camera-connection recognition signal
circuit

Camera control unit

AV (NAVI) control unit

FLASH-ROM Error Of Control Unit

AV (NAVI) control unit malfunction is
detected

Replace AV (NAVI) control unit
Refer to

AV-131, "AV (NAVI) Control Unit"

Connection Of Gyro

NAVI control unit malfunction is
detected

Replace NAVI control unit
Refer to

AV-131, "AV (NAVI) Control Unit"

GPS Communication Error

GPS malfunction is detected

If the symptoms such as the GPS receipt
malfunction occur, intermittent malfunction
caused by strong radio interference may
be detected.
If the malfunction always occurs, replace
NAVI control unit.

GPS ROM Error

GPS RAM Error

GPS RTC Error

DVD-ROM Communication Error

Malfunction is detected on DVD-
ROM drive pickup lens in NAVI con-
trol unit

There is dirt and damage on the map
disc

Map disc

NAVI control unit
Refer to

AV-131, "AV (NAVI) Control

Unit"

DVD-ROM Read Error

DVD-ROM Disc Error

DVD-ROM Mechanism not Detected

DVD-ROM Mechanism Error

DVD-ROM Focus Error

DVD-ROM TOC Error

DVD-ROM Seek Error

DVD-ROM Error Correction Error

DVD-ROM Data Transfer Error

DVD-ROM Data Error

DVD-ROM Time-out

DVD-ROM Loading / Eject Error

CAN Controller Memory Error

AV (NAVI) control unit malfunction is
detected

Replace AV (NAVI) control unit
Refer to

AV-131, "AV (NAVI) Control Unit"

Bluetooth Module Connection Error

Error item

Description

Possible cause/Action to take

Была ли эта страница вам полезна?
Да!Нет
2 посетителя считают эту страницу полезной.
Большое спасибо!
Ваше мнение очень важно для нас.

Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.

Текст

Политика конфиденциальности