Infiniti M35/M45 Y50. Manual — part 149
DUCTS AND GRILLES
ATC-147
C
D
E
F
G
H
I
K
L
M
A
B
ATC
Removal of Rear Ventilator Grille
1.
Remove console rear finisher. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
.
2.
Remove mounting clips, and then remove rear ventilator grille.
Removal of Rear Ventilator Ducts
1.
Remove center console. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
2.
Remove mounting clip, and then remove rear ventilator duct 2.
3.
Remove mounting clips, and then remove rear ventilator ducts
1.
4.
Remove mounting screws, and then remove rear ventilator duct
3.
RJIA4139E
RJIA4140E
RJIA4141E
RJIA4142E
ATC-148
DUCTS AND GRILLES
Removal of Foot Grilles
1.
Remove mounting clips, and then remove foot grille (left).
2.
Remove mounting clips, and then remove foot grille (right).
Removal of Foot Ducts
1.
Remove instrument driver lower panel. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
.
2.
Remove mounting screws, and then remove heater pipe cover.
3.
Remove mounting screws, and then remove foot duct (left).
4.
Remove blower unit. Refer to
5.
Remove air mix door motor (passenger side). Refer to
6.
Remove mode door motor (passenger side). Refer to
7.
Remove mounting screws, and then remove evaporator cover.
8.
Remove mounting screws, and then remove foot duct (right).
RJIA4143E
RJIA4144E
RJIA4145E
RJIA4146E
DUCTS AND GRILLES
ATC-149
C
D
E
F
G
H
I
K
L
M
A
B
ATC
Removal of Rear Floor Grilles
1.
Slide front seats toward vehicle front.
2.
Remove mounting clips, and then remove rear floor grilles.
Removal of Rear Floor Ducts
1.
Remove center console. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
2.
Remove rear floor duct 1.
3.
Remove front seats. Refer to
4.
Peel back floor trim to a point where rear floor duct is visible.
5.
Remove mounting screws and clip, and then remove rear floor
ducts 2 and 3.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA4147E
RJIA4149E
RJIA4148E
ATC-150
REFRIGERANT LINES
REFRIGERANT LINES
PFP:92600
HFC-134a (R-134a) Service Procedure
NJS000HM
SETTING OF SERVICE TOOLS AND EQUIPMENT
Discharging Refrigerant
WARNING:
Avoid breathing A/C refrigerant and lubricant vapor or mist. Exposure may irritate eyes, nose and
throat. Remove HFC-134a (R-134a) from A/C system using certified service equipment meeting
requirements of SAE J-2210 [HFC-134a (R-134a) recycling equipment] or J-2209 [HFC-134a (R-134a)
recovery equipment]. If accidental system discharge occurs, ventilate work area before resuming ser-
vice. Additional health and safety information may be obtained from refrigerant and lubricant manu-
facturers.
Evacuating System and Charging Refrigerant
WJIA0614E
WJIA0615E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст