Infiniti M35/M45 Y50. Manual — part 187
TROUBLE DIAGNOSIS
AV-125
[WITHOUT MOBILE ENTERTAINMENT SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
AV
Rear view monitor image is not
clear
Front glass of camera lens is dirty
Dip a soft cloth into water and wipe the
glass softly.
There are raindrops, snow, etc.
Wipe it with a soft cloth softly.
The sunlight or the headlight of following vehicle is
shining directly to the camera lens.
It returns to the original condition if the light
applied to the lens disappears
The center position of possible
route line is not in the correct posi-
tion
●
Remove or replace the battery.
●
Replace steering angle sensor or camera control
unit.
●
Turn steering wheel when turning ignition switch
OFF.
Perform the neutral position correction as
follows.
●
Fully turn the steering wheel to left/right.
●
Drive 100 m or more at vehicle speed 30
km/h or more.
Symptom
Possible cause
Possible solution
AV-126
[WITHOUT MOBILE ENTERTAINMENT SYSTEM]
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
PFP:00000
Removal and Installation/Precautions for Replacement
NKS0049F
REMOVAL OF BATTERY
When the battery is removed, the possible route line center position of rear view monitor may not be in the cor-
rect position. Perform the center position correction with the following procedure.
1.
Fully turn the steering wheel to left/right.
2.
Drive 100 m (328.1 ft) or more at vehicle speed 30 km/h (18.6 MPH) or more.
Audio Unit
NKS0049G
REMOVAL
1.
Remove cluster lid C. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
2.
Remove screws (A) and remove audio unit (2) in conjunction
with unified meter and A/C amp (1).
3.
Remove screws (A) and (B)
4.
Remove meter and A/C amp (1), audio unit (2) and bracket (3).
CAUTION:
Be careful not to allow foreign material to enter from CD
slot.
INSTALLATION
Installation is the reverse order of removal.
CAUTION:
Unified meter and A/C amp screws are different from other securing screws. Never confuse them
when installing.
Front Door Speaker
NKS0049H
REMOVAL
1.
Remove front door finisher. Refer to
2.
Remove screws (A) and remove front door speaker (1).
INSTALLATION
Installation is the reverse order of removal.
SKIB4268E
SKIB4269E
SKIB4270E
REMOVAL AND INSTALLATION
AV-127
[WITHOUT MOBILE ENTERTAINMENT SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
AV
Rear Door Speaker
NKS0049I
REMOVAL
1.
Remove rear door finisher. Refer to
2.
Remove screws (A) and remove rear door speaker (1).
INSTALLATION
Installation is the reverse order of removal.
Tweeter
NKS0049J
REMOVAL
1.
Remove front door finisher. Refer to
2.
Remove door sash inner cover (front). Refer to
.
3.
Remove screws (A), and disconnect connector (1).
4.
Remove tweeter (2).
INSTALLATION
Installation is the reverse order of removal.
Center Speaker
NKS0049K
REMOVAL
1.
Remove upper ventilator grill. Refer to
2.
Remove screws (A) and disconnect connector.
3.
Remove center speaker (1).
INSTALLATION
Installation is the reverse order of removal.
SKIB4271E
SKIB4272E
SKIB4345E
AV-128
[WITHOUT MOBILE ENTERTAINMENT SYSTEM]
REMOVAL AND INSTALLATION
Seat Speaker
NKS0049L
REMOVAL
1.
Remove seat speaker grill as shown in the figure.
CAUTION:
Never reuse seat speaker grill. The pawl is broken when
removing.
2.
Remove front seat back trim and pad. Refer to
.
3.
Remove screws (A) and disconnect connector (1).
4.
Remove seat speaker (2).
INSTALLATION
Installation is the reverse order of removal.
Rear Surround Speaker
NKS0049M
REMOVAL
1.
Remove rear parcel shelf finisher. Refer to
EI-42, "Removal and Installation"
2.
Remove screws (A) and disconnect connector.
3.
Remove rear surround speaker (1).
INSTALLATION
Installation is the reverse order of removal.
Woofer
NKS0049N
REMOVAL
1.
Remove rear parcel shelf finisher. Refer to
EI-42, "Removal and Installation"
SKIB3584J
SKIB4346E
SKIB4347E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст