Infiniti M35/M45 Y50. Manual — part 1133
AWD CONTROL UNIT
TF-39
C
E
F
G
H
I
J
K
L
M
A
B
TF
AWD CONTROL UNIT
PFP:41650
Removal and Installation
NDS000E0
REMOVAL
1.
Remove the dash side finisher. Refer to
2.
Disconnect AWD control unit connector.
3.
Remove the AWD control unit.
INSTALLATION
Install in the reverse order of removal.
SDIA3137E
TF-40
FRONT OIL SEAL
FRONT OIL SEAL
PFP:38189
Removal and Installation
NDS000E1
REMOVAL
1.
Remove the drain plug to drain the transfer fluid. Refer to
2.
Remove the front propeller shaft. Refer to
3.
Remove front oil seal using a flat-bladed screwdriver.
CAUTION:
Be careful not to damage the front case and front drive
shaft.
INSTALLATION
1.
Apply ATF to front oil seal, install it with a drift until the end face
of front case.
CAUTION:
●
Do not reuse front oil seal.
●
When installing, do not incline front oil seal.
2.
Install front propeller shaft. Refer to
3.
Install transfer fluid, check fluid level and for fluid leakage. Refer
to
.
SDIA1782E
Tool number
: ST27862000 (
—
)
SDIA1783E
REAR OIL SEAL
TF-41
C
E
F
G
H
I
J
K
L
M
A
B
TF
REAR OIL SEAL
PFP:33140
Removal and Installation
NDS000E2
REMOVAL
1.
Remove the rear propeller shaft. Refer to
2.
Remove self-lock nut of companion flange using a flange
wrench.
3.
Put matching mark on the end of the mainshaft. The mark
should be in line with the mark on the companion flange.
CAUTION:
For matching mark, use paint. Do not damage mainshaft.
4.
Remove the companion flange using a puller.
CAUTION:
Be careful not to damage the companion flange.
5.
Remove the rear oil seal using the puller.
CAUTION:
Be careful not to damage the rear case.
SDIA2454E
SDIA2378E
SDIA1785E
Tool number
: KV381054S0 (J-34286)
SDIA1786E
TF-42
REAR OIL SEAL
INSTALLATION
1.
Apply ATF to rear oil seal, install it with a drifts.
CAUTION:
●
Do not reuse rear oil seal.
●
When installing, do not incline rear oil seal.
2.
Align the matching mark of mainshaft with the mark of compan-
ion flange, then install the companion flange.
3.
Using a flange wrench, install the self-lock nut of companion
flange and tighten to the specified torque. Refer to
CAUTION:
Do not reuse self-lock nut.
4.
Install the rear propeller shaft. Refer to
5.
Check fluid level. Refer to
Dimension A
: 6.7 - 7.3 mm (0.264 - 0.287 in)
Tool number
A: ST30720000 (J-25405)
B: KV40104830 (
—
)
PDIA0292E
SDIA2378E
PDIA0245E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст