Infiniti M35/M45 Y50. Manual — part 236
SQUEAK AND RATTLE TROUBLE DIAGNOSIS
BL-13
C
D
E
F
G
H
J
K
L
M
A
B
BL
Diagnostic Worksheet
NIS001WI
PIIB8741E
BL-14
SQUEAK AND RATTLE TROUBLE DIAGNOSIS
PIIB8742E
HOOD
BL-15
C
D
E
F
G
H
J
K
L
M
A
B
BL
HOOD
PFP:F5100
Fitting Adjustment
NIS001WJ
PIIB5793E
BL-16
HOOD
1.
Check the clearance and the surface height between the hood and each part by visual and tactile feeling.
(Fitting standard dimension in the table below should be satisfied.)
* Unit: mm (in)
2.
In case out of specification, adjust them according to the procedures shown below.
3.
Remove the hood lock and adjust the height by rotating the
bumper rubber until the hood becomes 1 to1.5 mm (0.04 to
0.059 in) lower than the fender.
4.
Temporarily tighten the hood lock, and position by engaging it with the hood striker. Check the lock and
striker for looseness and adjust the clearance and evenness by the striker to satisfy the specification.
5.
Adjust A and B shown in the figure to the following value with hood's own weight by dropping it from
approx. 200 mm (7.87 in) height or the hood pressed lightly (approx. 29 N (3 kg)).
6.
After adjustment tighten lock bolts to the specified torque.
1.
Hood hinge
2.
Hood lock assembly
3.
Hood assembly
4.
Hood top molding
5.
Bumper fascia assembly
6.
Headlamp
7.
Front fender
Parts
Standard
Right/left clearance (MAX)
A – A
a
Clearance
0.5 - 1.2 (0.02 -0.05)
—
e
Surface height
0.5 - 2.5 (0.02 - 0.10)
—
B – B
b
Clearance
1.5 - 5.5 (0.06 - 0.22)
2.5 (0.01)
f
Surface height
-1.0 - 3.0 (-0.04 - 0.12)
2.0 (0.08)
C – C
c
Clearance
1.5 - 5.5 (0.06 - 0.22)
2.0 (0.08)
g
Surface height
-1.0 - 3.0 (-0.40 - 0.12)
2.0 (0.08)
D – D
d
Clearance
2.0 - 5.0 (0.08 - 0.20)
1.5 (0.06)
h
Surface height
-1.0 - 1.0 (-0.04 - 0.04)
1.5 (0.06)
PIIB3872J
1.
Hood striker
2.
Primary latch
3.
Secondary striker
4.
Secondary latch
A
: 20 mm (0.79 in)
B
: 6.8 mm (0.27 in)
PIIB5794E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст