Infiniti M35/M45 Y50. Manual — part 836
INSTRUMENT PANEL ASSEMBLY
IP-13
C
D
E
F
G
H
J
K
L
M
A
B
IP
13. Remove instrument driver lower panel.
●
Remove hood opener mounting bolt. Refer to
"Removal and Installation of Hood Lock Control"
●
Pull back.
●
Disconnect harness connector.
14. Remove instrument finisher A.
●
Insert a remover into upper space.
15. Remove instrument finisher C.
●
Insert a remover into upper space
16. Remove cluster lid A
●
Pull back.
17. Remove combination meter. Refer to
DI-27, "Removal and Installation of Combination Meter"
.
18. Remove steering column cover with power tool.
19. Remove upper ventilator grille.Refer to
.
PIIB4112E
PIIB4113E
PIIB4114E
PIIB6503E
IP-14
INSTRUMENT PANEL ASSEMBLY
20. Remove center ventilator grille.
●
Insert a remover into rear lower space.
●
Pull up.
21. Remove multifunction switch. Refer to
AV-284, "Multifunction Switch"
.
22. Remove front display unit. Refer to
.
23. Remove audio assembly. Refer to
.
24. Remove NAVI C/U. Refer to
AV-282, "AV (NAVI) Control Unit"
25. Remove side ventilator grille (RH/LH).
●
Insert a remover into lower space.
●
Pull back.
26. Remove front defroster grille.
●
Insert a remover into back space.
●
Disconnect harness connector.
27. Remove instrument panel & pad.
●
Remove front passenger air bag module mounting bolt and disconnect harness connector. Refer to
SRS-46, "FRONT PASSENGER AIR BAG MODULE"
●
Remove front pillar garnish. Refer to
INSTALLATION
Install in the reverse order of removal.
CAUTION:
●
To install, confirm locating pins on back of instrument panel are completely inserted into holes on
vehicle.
●
Do not leave harness stuck when installing.
PIIB4121E
PIIB4123E
PIIB4122E
INSTRUMENT PANEL ASSEMBLY
IP-15
C
D
E
F
G
H
J
K
L
M
A
B
IP
Removal and Installation of Cluster Lid A
NIS0025E
●
When removing cluster lid A assembly, take steps in the illustration shown by the number below.
●
:Pawl
●
:Clip
●
:Metal clip
REMOVAL
1.
Remove instrument side finisher.
●
Insert a remover into lower space.
2.
Remove instrument driver lower panel.
●
Remove hood opener mounting bolt. Refer to
"Removal and Installation of Hood Lock Control"
●
Pull back.
●
Disconnect harness connector.
1.
Instrument side finisher (LH)
2.
Instrument driver lower panel
3.
Instrument finisher A
4.
Instrument finisher C
5.
Cluster lid A
PIIB3111E
PIIB4111E
PIIB4112E
IP-16
INSTRUMENT PANEL ASSEMBLY
3.
Remove instrument finisher A.
●
Insert a remover into upper space.
4.
Remove instrument finisher C.
●
Insert a remover into upper space.
5.
Remove cluster lid A.
●
Pull back.
INSTALLATION
Install in the reverse order of removal.
PIIB4113E
PIIB4114E
PIIB6503E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст