Infiniti M35/M45 Y50. Manual — part 775

FUEL TANK

FL-11

C

D

E

F

G

H

I

J

K

L

M

A

FL

7.

Disconnect fuel filler hose, vent hose and EVAP hoses at fuel
tank side.

8.

Support the lower part of fuel tank with transmission jack.

CAUTION:

Support the position that fuel tank mounting bands do not
engage.

9.

Remove fuel tank mounting bands.

10. Supporting with hands, descend transmission jack carefully, and remove fuel tank.

CAUTION:

●

Make sure that all connection points have been disconnected.

●

Confirm there is no interference with vehicle.

11. Remove fuel filler tube, as necessary.

INSTALLATION

Note the following, and install in the reverse order of removal.

●

Surely clamp fuel hoses and insert hose to the length below.

●

Be sure hose clamp is not placed on swelled area of fuel tube.

●

Tighten the clamp hand with the top mark until the mark is on the
bolt head flange “A”.

●

To connect quick connector, refer to

FL-7, "Quick Connector"

.

INSPECTION AFTER INSTALLATION

Use the following procedure to check for fuel leaks.

1.

Turn ignition switch “ON” (with engine stopped), and check connections for leakage by applying fuel pres-
sure to fuel piping.

PBIC1581E

PBIC0878E

Fuel filler hose

: 35 mm (1.38 in)

The other hoses

: 25 mm (0.98 in)

PBIC3388E

FL-12

FUEL TANK

2.

Start engine and rev it up and make sure there are no fuel leaks at the fuel system tube and hose connec-
tions.

●

After removing/installing rear suspension assembly, make sure to adjust wheel alignment and then, adjust
neutral position of steering angle sensor. Refer to

RSU-5, "Wheel Alignment Inspection"

and

BRC-6,

"Adjustment of Steering Angle Sensor Neutral Position"

.

SERVICE DATA AND SPECIFICATIONS (SDS)

FL-13

C

D

E

F

G

H

I

J

K

L

M

A

FL

SERVICE DATA AND SPECIFICATIONS (SDS)

PFP:00030

Standard and Limit

NBS005RG

FUEL TANK

Fuel tank capacity

Approx. 76

(20-1/8 US gal, 16-3/4 Imp gal)

Fuel recommendation

Refer to

GI-6

FL-14

SERVICE DATA AND SPECIFICATIONS (SDS)