Infiniti FX35 / FX45. Manual — part 87
AT-276
< SERVICE INFORMATION >
DISASSEMBLY
i.
Remove tightening bolts for rear extension assembly and trans-
mission case.
ii.
Tap rear extension assembly with soft hammer.
iii.
Remove rear extension assembly from transmission case. (With
needle bearing.)
b.
AWD models
i.
Remove tightening bolts (1) for adapter case assembly and
transmission case. [With bracket (2).]
: Bolt (10)
• Self-sealing bolts (3)
SCIA6941E
SCIA5028E
SCIA5029E
SCIA7210E
DISASSEMBLY
AT-277
< SERVICE INFORMATION >
D
E
F
G
H
I
J
K
L
M
A
B
AT
N
O
P
ii.
Tap adapter case assembly with soft hammer.
iii.
Remove adapter case assembly from transmission case. (With
needle bearing)
iv.
Remove gasket from transmission case.
45. Remove bearing race from output shaft.
46. Remove output shaft from transmission case by rotating left/
right.
SCIA5201E
SCIA5186E
SCIA5231E
SCIA5245E
SCIA5030E
AT-278
< SERVICE INFORMATION >
DISASSEMBLY
47. Remove parking gear from output shaft.
48. Remove seal rings from output shaft.
49. Remove needle bearing from transmission case.
50. Remove revolution sensor from transmission case.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings, etc. to get on the sensor's front
edge magnetic area.
• Do not place in an area affected by magnetism.
51. Remove reverse brake snap ring (fixing plate) using 2 flat-
bladed screwdrivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using another
screwdriver.
52. Remove reverse brake retaining plate from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
SCIA5247E
SCIA5209E
SCIA5031E
SCIA2320E
SCIA5032E
DISASSEMBLY
AT-279
< SERVICE INFORMATION >
D
E
F
G
H
I
J
K
L
M
A
B
AT
N
O
P
53. Remove N-spring from transmission case.
54. Remove reverse brake drive plates, driven plates and dish plate
from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
55. Remove snap ring (fixing spring retainer) using a flat-bladed
screwdriver.
56. Remove spring retainer and return spring from transmission
case.
57. Remove seal rings from drum support.
SCIA5214E
SCIA2322E
SCIA2323E
SCIA2324E
SCIA3333E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст