Infiniti FX35 / FX45. Manual — part 743
GW-56
< SERVICE INFORMATION >
REAR DOOR GLASS AND REGULATOR
10. Remove the power window motor mounting bolts and nuts, and
remove the regulator from the panel.
11. Disconnect the connector for the regulator assembly.
Installation
Install in the reverse order of removal.
Inspection after Removal
Check the regulator assembly for the following. If a malfunction is
detected, replace or grease it.
• Gear wear
• Regulator deformation
• Spring damage
• Grease condition for each sliding part
The arrows in the figure show the application points of the body
grease.
Disassembly and assembly
INFOID:0000000001327994
REGULATOR ASSEMBLY
Disassembly
Remove the power window motor from the regulator assembly.
Assembly
Assemble in the reverse order of disassembly.
Fitting Inspection
INFOID:0000000001327995
• Check that the glass is securely fit into the glass run groove.
• Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)], and make sure the clearance to the sash is
parallel. Loosen the regulator mounting bolts, guide rail mounting bolts, and glass and carrier plate mounting
bolts to correct the glass position if the clearance between the glass and sash is not parallel.
PIIA4736E
PIIA4935E
INSIDE MIRROR
GW-57
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
M
A
B
GW
N
O
P
INSIDE MIRROR
Wiring Diagram - I/MIRR -
INFOID:0000000001327996
TIWM1683E
GW-58
< SERVICE INFORMATION >
INSIDE MIRROR
Removal and Installation
INFOID:0000000001327997
REMOVAL
1.
Remove inside mirror cover.
2.
Remove inside mirror finisher.
3.
Remove TORX bolt from mirror base.
4.
Slide the mirror base upward to remove.
5.
Disconnect the connector.
NOTE:
Insert minus deriver (A) under the inside mirror (1). Slide the inside
mirror to the upper side while pushing the pawl downward.
CAUTION:
• Do not use excessive force to remove the inside mirror
because it is inserted tightly into the mirror base.
• Do not reuse the inside mirror disassembled from mirror
base.
INSTALLATION
Install in the reverse order of removal.
COMPASS
For reset of compass, refer to
CAUTION:
• When inserting the inside mirror into mirror base, be sure to push the pawl until it get connected to
the mirror base.
1.
Inside mirror finisher
2.
Inside mirror
3.
TORX bolt
4.
Inside mirror cover
PIIA4934E
PIIB9501J
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст