Infiniti Q45 (FY33). Manual — part 57
SAT681A
b.
Install reamer bolts from bottom of upper body.
SAT063E
c.
Place oil circuit of lower body face up. Install orifice check
springs, orifice check valves and pilot filter.
SAT197B
d.
Install separator plate on lower body.
e.
Install and temporarily tighten support plates, fluid temperature
sensor and tube brackets.
SAT198B
f.
Temporarily assemble lower and upper bodies, using reamer
bolt as a guide.
I
Be careful not to dislocate or drop steel balls, orifice
check spring, orifice check valve and pilot filter.
GI
MA
EM
LC
EC
FE
PD
FA
RA
BR
ST
RS
BT
HA
EL
IDX
REPAIR FOR COMPONENT PARTS
Control Valve Assembly (Cont’d)
AT-225
SAT199BA
g.
Install and temporarily tighten bolts and tube brackets in their
proper locations.
Bolt length and location:
Item
Bolt symbol
q
a
q
b
q
c
q
d
Bolt length
mm (in)
70
(2.76)
50
(1.97)
33
(1.30)
27
(1.06)
SAT200B
2.
Install solenoids.
a.
Attach O-ring and install torque converter clutch solenoid valve
and side plates onto lower body.
SAT150G
b.
Attach O-rings and install 3-unit solenoids assembly onto
upper body.
c.
Attach O-ring and install line pressure solenoid valve onto
upper body.
3.
Tighten all bolts.
REPAIR FOR COMPONENT PARTS
Control Valve Assembly (Cont’d)
AT-226
Control Valve Upper Body
Numbers preceding valve springs correspond with those shown in SDS table on page AT-277.
Apply ATF to all components before their installation.
SAT743J
GI
MA
EM
LC
EC
FE
PD
FA
RA
BR
ST
RS
BT
HA
EL
IDX
REPAIR FOR COMPONENT PARTS
AT-227
SAT834A
DISASSEMBLY
1.
Remove valves at parallel pins.
I
Do not use a magnetic hand.
SAT822A
a.
Use a wire paper clip to push out parallel pins.
SAT823A
b.
Remove parallel pins while pressing their corresponding plugs
and sleeves.
I
Remove plug slowly to prevent internal parts from jump-
ing out.
SAT824A
c.
Place mating surface of valve facedown, and remove internal
parts.
I
If a valve is hard to remove, place valve body facedown
and lightly tap it with a soft hammer.
I
Be careful not to drop or damage valves and sleeves.
SAT825A
2.
Remove valves at retainer plates.
a.
Pry out retainer plate with wire paper clip.
REPAIR FOR COMPONENT PARTS
Control Valve Upper Body (Cont’d)
AT-228
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст