Infiniti M45 (Y34). Manual — part 193
NAVIGATION SYSTEM
AV-105
C
D
E
F
G
H
I
J
L
M
A
B
AV
THE CURRENT POSITION MARK SHOWS A POSITION WHICH IS COMPLETELY WRONG
In the following cases, the current-location mark may appear on completely different position in the map
depending on the GPS satellite signal receiving conditions. In this case, perform location correction and direc-
tion correction.
●
When location correction has not been done
–
If the receiving conditions of the GPS satellite signal is poor, if the current-location mark becomes out of
place, it may move to a completely different location and not come back if location correction is not done.
The position will be corrected if the GPS signal can be received.
●
When the vehicle has traveled by ferry, or when the vehicle has been being towed
–
Because calculation of the current location cannot be done when travelling with the ignition OFF, for
example when traveling by ferry or when being towed, the location before travel is displayed. If the precise
location can be detected with GPS, the location will be corrected.
THE CURRENT POSITION MARK JUMPS
In the following cases, the current-location mark may appear to jump as a result of automatic correction of the
current location.
●
When map matching has been done
–
If the current location and the current-location mark are different when map matching is done, the current-
location mark may seem to jump. At this time, the location may be “corrected” to the wrong road or to a
location which is not on a road.
●
When GPS location correction has been done
–
If the current location and the current-location mark are different when the location is corrected using GPS
measurements, the current-location mark may seem to jump. At this time, the location may be “corrected”
to a location which is not on a road.
Precautions
for driving
Just after the engine is started
If the vehicle is driven off just after the
engine is started when the gyroscope
(angular speed sensor) correction is not
completed, the vehicle can lose its direc-
tion and may have deviated from the cor-
rect location.
Wait for a short while before
driving after starting the engine.
Continuous driving without stopping
When driving long distances without stop-
ping, direction errors may accumulate, and
the current-location mark may deviate from
the correct road.
Stop and adjust the orientation.
Abusive driving
Spinning the wheels or engaging in other
kinds of abusive driving may result in the
system being unable perform correct
detection, and may cause the vehicle mark
to deviate from the correct road.
If after travelling about 10 km (6
miles) the correct location has
not been restored, perform
location correction and, if nec-
essary, direction correction.
How to cor-
rect location
Position correction accuracy
If the accuracy of location settings is poor,
accuracy may be reduced when the correct
road cannot be found, particularly in places
where there are many roads.
Enter in the road displayed on
the screen with an accuracy of
approx. 1 mm (0.04 in).
CAUTION:
Whenever possible, use
detailed map for the correc-
tion.
Direction when location is corrected
If the accuracy of location settings during
correction is poor, accuracy may be
reduced afterwards.
Perform direction correction.
Cause (condition)
-:While driving
ooo:Display
Driving condition
Remarks (correction, etc.)
SEL699V
SEL702V
AV-106
NAVIGATION SYSTEM
THE CURRENT LOCATION MARK IS IN A RIVER OR THE SEA
The navigation system moves the current location mark with no distinction between land and rivers or sea. If
the location mark is somehow out of place, it may appear that the vehicle is driving in a river or the sea.
WHEN DRIVING ON THE SAME ROAD, SOMETIMES THE CURRENT-LOCATION MARK IS IN
THE RIGHT PLACE AND SOMETIMES IT IS THE WRONG PLACE
The conditions of the GPS antenna (GPS data) and gyroscope (angular speed sensor) change gradually.
Depending on the road traveled and the operation of the steering wheel, the location detection results will be
different. Therefore, even on a road on which the location has never been wrong, conditions may cause the
vehicle mark to deviate.
LOCATION CORRECTION BY MAP MATCHING IS SLOW
●
The map matching function needs to refer to the data of the surrounding area. It is necessary to drive
some distance for the function to work.
●
Because map matching operates on this principle, when there are many roads running in similar direc-
tions in the surrounding area, no matching determination may be made. The location may not be cor-
rected until some special feature is found.
ALTHOUGH THE GPS RECEIVING DISPLAY IS GREEN, THE VEHICLE MARK DOES NOT
RETURN TO THE CORRECT LOCATION
●
The GPS accuracy has an error of about 10 m (30 ft). In some cases the current-location mark may not be
on the correct street, even when GPS location-correction is done.
●
The navigation system compares the results of GPS location detection with the results from map-match-
ing location detection. The one which is determined to have higher accuracy is used.
●
GPS location correction may not be performed when the vehicle is stopped.
THE NAME OF THE CURRENT PLACE IS NOT DISPLAYED
The current place name may not be displayed if there are no place names displayed on the map screen.
CONTENTS OF THE DISPLAY DIFFER FOR THE BIRDVIEW™ AND THE (FLAT) MAP SCREEN
Difference of the BIRDVIEW™ screen from the flat map screen are as follows.
●
The current place name displays names which are primarily in the direction of vehicle travel.
●
The amount of time before the vehicle travel or turn angle is updated on the screen is longer than for the
(flat) map display.
●
The conditions for display of place names, roads, and other data are different for nearby areas and for
more distant areas.
●
Some thinning of the character data is done to prevent the display becoming to complex. In some cases
and in some locations, the display contents may differ.
●
The same place name, street name, etc. may be displayed multiple times.
NAVIGATION SYSTEM
AV-107
C
D
E
F
G
H
I
J
L
M
A
B
AV
Program Loading
AKS003Y5
SKIA0389E
AV-108
NAVIGATION SYSTEM
Removal and Installation of AV and NAVI Control Unit
AKS002P6
REMOVAL
1.
Refer to
AV-49, "Precautions for AV and NAVI Control Unit Replacement"
. Take a note of necessary
items.
2.
Remove trunk front finisher. Refer to
EI-42, "Removal and Installation"
3.
Remove screws (4), and remove AV and NAVI control unit with
power tool.
INSTALLATION
Install in the reverse order of removal.
Removal and Installation of GPS Antenna
AKS002P7
REMOVAL
1.
Remove trunk front finisher, and disconnect GPS antenna harness connector. Refer to
.
2.
Remove rear parcel shelf finisher. Refer to
3.
Remove screws (2), and remove GPS antenna.
INSTALLATION
Install in the reverse order of removal.
Removal and Installation of Steering Wheel Switch
AKS002P8
Refer to
SRS-38, "DRIVER AIR BAG MODULE"
.
PKIA1672E
PKIA1688E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст