Infiniti M45 (Y34). Manual — part 645
FRONT FOG LAMP
LT-87
C
D
E
F
G
H
I
J
L
M
A
B
LT
2.
CHECK FRONT FOG LAMP CIRCUIT
1.
Turn ignition switch OFF.
2.
Disconnect front fog lamp connector.
3.
Check continuity between front fog lamp harness connector ter-
minal 1 (B) of lamp which does not illuminate and ground.
OK or NG
OK
>> Check harness for open or short between front fog lamp
relay and front fog lamp.
NG
>> Repair harness.
Aiming Adjustment
AKS003RV
The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming
adjustment, make sure of the following.
●
Keep all tires inflated to correct pressure.
●
Place vehicle on level ground.
●
See that vehicle is unloaded (except for full levels of coolant,
engine oil and fuel, and spare tire, jack, and tools). Have the
driver or equivalent weight placed in driver seat.
Adjust aiming in the vertical direction by turning the adjusting screw.
1.
Set the distance between the screen and the center of fog lamp
lens as shown.
2.
Turn front fog lamps ON.
1 (B) - Ground
: Continuity should exist.
PKIA5920E
PKIA2244E
MEL327G
LT-88
FRONT FOG LAMP
3.
Adjust front fog lamps using adjusting screw so that the top edge
of the high intensity zone is 100 mm (3.94 in) below the height of
the fog lamp centers as shown.
●
When performing adjustment, if necessary, cover headlamps
and opposite fog lamp.
Bulb Replacement, Removal and Installation
AKS003RX
1.
Remove fender protector. Refer to
2.
Disconnect front fog lamp connector.
3.
Remove nuts, and slide fog lamp out of front bumper fascia.
4.
Turn the plastic cap counterclockwise and unlock it.
5.
Unlock the retaining spring and remove the bulb from the front
fog lamp.
6.
Install in the reverse order of removal.
CAUTION:
●
Do not touch the glass of bulb directly by hand. Keep
grease and other oily matters away from it. Do not touch
bulb by hand while it is lit or right after being turned off.
Burning may result.
●
Do not leave bulb out of fog lamp reflector for a long time because dust, moisture smoke, etc. May
affect the performance of fog lamp. When replacing bulb, be sure to replace it with new one.
PKIA7887E
PKIA2248E
Fog lamp
:12V – 55W (H3 halogen)
PKIA2247E
TURN SIGNAL AND HAZARD WARNING LAMPS
LT-89
C
D
E
F
G
H
I
J
L
M
A
B
LT
TURN SIGNAL AND HAZARD WARNING LAMPS
PFP:26120
Component Parts and Harness Connector Location
AKS00AS4
System Description
AKS002FT
TURN SIGNAL LAMP OPERATION
When the ignition switch in the ON or START position,
power is supplied
●
through 10A fuse [No. 5, located in fuse block (J/B) No. 1]
●
to combination flasher unit terminal 1
●
through combination flasher unit terminal 2
●
to combination switch (turn signal) terminal 1.
Ground is supplied
●
to combination flasher unit terminal 7
●
through grounds M24 and M114.
Turn Signal Lamp LH
When the combination switch (turn signal) is moved to the L position, power is supplied
●
through combination switch (turn signal) terminal 3
●
to front combination lamp LH terminal 3
●
to rear combination lamp LH terminal 5
●
to door mirror (driver side) terminal 7
●
to combination meter terminal 19.
Ground is supplied
●
to front combination lamp LH terminal 2 through grounds E24, E42 and E62
●
to rear combination lamp LH terminal 6 through grounds B17and B57
●
to door mirror (driver side) terminal 5 through grounds M24 and M114
●
to combination meter terminal 45 through grounds M24 and M114.
With power and ground supplied, the combination flasher unit controls the flashing of the LH turn signal lamps.
Turn Signal Lamp RH
When the combination switch (turn signal) is moved to the R position, power is supplied
●
through combination switch (turn signal) terminal 2
●
to front combination lamp RH terminal 3
●
to rear combination lamp RH terminal 5
●
to door mirror (passenger side) terminal 7
PKIA6943E
LT-90
TURN SIGNAL AND HAZARD WARNING LAMPS
●
to combination meter terminal 41.
Ground is supplied
●
to front combination lamp RH terminal 2 through grounds E24, E42 and E62
●
to rear combination lamp RH terminal 6 through grounds B17 and B57
●
to door mirror (passenger side) terminal 5 through grounds M24 and M114
●
to combination meter terminal 45 through grounds M24 and M114.
With power and ground supplied, the combination flasher unit controls the flashing of the RH turn signal
lamps.
HAZARD LAMP OPERATION
Power is supplied at all times
●
through 15A fuse [No. 22, located in fuse block (J/B) No. 1]
●
to combination flasher unit terminal 4
●
through combination flasher unit terminal 6
●
to hazard switch terminal 1.
With the hazard switch in the ON position,
Ground is supplied
●
to hazard switch terminal 2
●
through grounds M24 and M114.
Power is supplied
●
through combination flasher unit terminal 8
●
to front combination lamp LH terminal 3
●
to rear combination lamp LH terminal 5
●
to door mirror (driver side) terminal 7
●
to combination meter terminal 19.
Power is supplied
●
through combination flasher unit terminal 3
●
to front combination lamp RH terminal 3
●
to rear combination lamp RH terminal 5
●
to door mirror (passenger side) terminal 7
●
to combination meter terminal 41.
Ground is supplied
●
to front combination lamp LH and RH terminals 2 through grounds E24, E42 and E62
●
to rear combination lamp LH and RH terminals 6 through grounds B17and B57
●
to door mirror driver side and passenger side terminals 5 through grounds M24 and M114
●
to combination meter terminal 45 through grounds M24 and M114.
With power and ground supplied, the combination flasher unit controls the flashing of the hazard warning
lamps.
MULTI-REMOTE CONTROL SYSTEM OPERATION
Power is supplied at all times
●
through 15A fuse [No. 22, located in fuse block (J/B) No. 1]
●
to combination flasher unit terminal 4.
Ground is supplied
●
to combination flasher unit terminal 6, when multi-remote control system is triggered through BCM.
Refer to
BL-51, "REMOTE KEYLESS ENTRY SYSTEM"
The BCM is energized.
Power is supplied
●
through combination flasher unit terminal 8
●
to front combination lamp LH terminal 3
●
to rear combination lamp LH terminal 5
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст