Infiniti M45 (Y34). Manual — part 650
BACK-UP LAMP
LT-107
C
D
E
F
G
H
I
J
L
M
A
B
LT
Bulb Replacement
AKS002G7
Refer to
LT-125, "REAR COMBINATION LAMP"
in PARKING, LICENSE PLATE AND TAIL LAMPS.
Removal and Installation
AKS002G8
Refer to
LT-127, "REAR COMBINATION LAMP"
in PARKING, LICENSE PLATE AND TAIL LAMPS.
LT-108
PARKING, LICENSE PLATE AND TAIL LAMPS
PARKING, LICENSE PLATE AND TAIL LAMPS
PFP:26550
Component Parts and Harness Connector Location
AKS00AS8
System Description
AKS002G9
The parking, license side marker and tail lamps operation are controlled by the lighting switch which is built
into the spiral cable and BCM. The battery saver system is controlled by the headlamp battery saver control
unit and BCM.
Power is supplied at all times
●
to tail lamp relay terminals 2 and 6
●
through 15A fuse [No. 54, located in fuse, fusible link and relay block (J/B)],
●
to headlamp battery saver control unit terminal 7
●
through 10A fuse [No. 6, located in fuse block (J/B) No. 1].
When ignition switch is in ON or START position,
power is supplied
●
to headlamp battery saver control unit terminal 1
●
through 10A fuse [No. 1, located in fuse block (J/B) No. 1].
Ground is supplied
●
to headlamp battery saver control unit terminals 4 and 11
●
through grounds M25 and M115.
LIGHTING OPERATION BY LIGHTING SWITCH
When lighting switch is in 1ST (or 2ND) position,
ground is supplied
●
to tail lamp relay terminal 1 from headlamp battery saver control unit terminals 6 and 14
●
through headlamp battery saver control unit terminals 5 and 13
●
through lighting switch terminals 11 and 5
●
through grounds M25 and M115.
Tail lamp relay is then energized and the parking, license, side marker and tail lamps illuminate.
BATTERY SAVER CONTROL
When the ignition switch is turned from ON (or START) to OFF (or ACC) positions while parking, license, side
marker and tail lamps are illuminated, the RAP signal is supplied to terminal 10 of headlamp battery saver
control unit terminal from BCM terminal 135.
After counting 45 seconds by the RAP signal from the BCM to headlamp battery saver control unit, the ground
supply to the tail lamp relay terminal 1 from headlamp battery saver control unit terminals 6 and 14 is termi-
nated.
PKIA6944E
PARKING, LICENSE PLATE AND TAIL LAMPS
LT-109
C
D
E
F
G
H
I
J
L
M
A
B
LT
Then the parking, license, side marker and tail lamps are turned off.
The parking, license, side marker and tail lamps are turned off when driver or passenger side door is opened
even if 45 seconds have not passed after the ignition switch is turned from ON (or START) to OFF (or ACC)
positions while the parking, license, side marker and tail lamps are illuminated.
When the lighting switch is turned from OFF to 1ST (or 2ND) after the parking, license, side marker and tail
lamps are turned off by the headlamp battery saver control, ground is supplied.
●
to headlamp battery saver control unit terminals 5 and 13 from lighting switch terminal 11, and
●
to tail lamp relay terminal 1 from headlamp battery saver control unit terminals 6 and 14.
Then the parking, license, side marker and tail lamps illuminate again.
LT-110
PARKING, LICENSE PLATE AND TAIL LAMPS
Schematic
AKS002GA
TKWA0535E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст