Infiniti M45 (Y34). Manual — part 681
CHASSIS AND BODY MAINTENANCE
MA-27
C
D
E
F
G
H
I
J
K
M
A
B
MA
Checking Seat Belts, Buckles, Retractors, Anchors and Adjusters
ALS0005W
ASCD Vacuum Hose
ALS000TG
Check vacuum hose (between ASCD actuator and ASCD pump) for
breakage, cracks or fracture.
PIIA1111E
MEL402G
MA-28
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
PFP:00030
Standard and Limit
ALS00024
BELT DEFLECTION AND TENSION
CAPACITY
Unit:
(US qt, Imp qt)
RADIATOR
Unit: kPa (kg/cm
2
, psi)
ENGINE OIL CAPACITY (APPROXIMATELY)
Unit:
(US qt, Imp qt)
SPARK PLUG (PLATINUM-TIPPED TYPE)
WHEEL BALANCE
Unit: g (oz)
Tightening Torque
ALS0007H
Unit: N·m (kg-m, ft-lb)
Unit: N·m (kg-m, in-lb)*
Tensions of drive belts
Auto-adjustment by auto tensioner
Engine coolant capacity (With reservoir tank at "MAX" level)
Approximately 9.8 (10-3/8, 8-5/8)
Reservoir tank engine coolant capacity (at "MAX" level)
0.8 (7/8, 3/4)
Cooling fan fluid capacity
777m
(26.3 US floz, 27.4 lmp floz)
Cap relief pressure
Standard
78 - 98 (0.8 - 1.0, 11 - 14)
Limit
59 (0.6, 9)
Leakage test pressure
157 (1.6, 23)
With oil filter change
5.6 (5-7/8, 4-7/8)
Without oil filter change
5.0 (5-1/4, 4-3/8)
Dry engine (engine overhaul)
6.7 (7-1/8, 5-7/8)
Make
NGK
Type
Standard
PLFR5A-11
Hot
PLFR4A-11
Cold
PLFR6A-11
Plug gap (Nominal)
1.1 mm (0.043 in)
Maximum allowable unbalance
Dynamic (At rim flange)
10 (0.35) (one side)
Static
20 (0.71)
Radiator drain plug
0.78 - 1.56 (0.08 - 0.16, 7 - 14)*
Oil pan drain plug
29.4 - 39.2 (3.0 - 4.0, 22 - 28)
Oil filter
14.7 - 20.6 (1.5 - 2.1, 11 - 15)
Spark plug
24.6 (2.5, 18)
PB-1
PARKING BRAKE SYSTEM
F BRAKES
CONTENTS
C
D
E
G
H
I
J
K
L
M
SECTION
PB
A
B
PB
PARKING BRAKE SYSTEM
PRECAUTIONS . . . . . . . . . . . . . . .. 2
PARKING BRAKE SYSTEM . . . . . . . . . .. 3
On-Vehicle Service . . . . . . . . . . . . ... 3
INSPECTION . . . . . . . . . . . . . . 3
ADJUSTMENT . . . . . . . . . . . . . .. 3
PARKING BRAKE CONTROL . . . . . . . . ... 4
Components . . . . . . . . . . . . . . . . 4
Removal and Installation . . . . . . . . . . .. 4
REMOVAL . . . . . . . . . . . . . . . . 4
INSTALLATION . . . . . . . . . . . . . . 4
Inspection . . . . . . . . . . . . . . . . . 4
PARKING BRAKE SHOE . . . . . . . . . . ... 5
Components . . . . . . . . . . . . . . . . 5
Removal and Installation . . . . . . . . . . .. 5
SERVICE DATA AND SPECIFICATIONS (SDS) . . 9
Parking Drum Brake . . . . . . . . . . . . . 9
Parking Brake Control . . . . . . . . . . . .. 9
PB-2
PRECAUTIONS
PRECAUTIONS
PFP:00001
Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”
AFS0029U
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
●
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
●
Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
●
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст